No, you can leave them in place as long as the circuit is dead and cannot be connected again.
A straight 220V circuit typically has 2 wires - one hot wire (typically black or red) and one neutral wire (typically white). These wires are used to carry the electrical current to and from the device being powered.
Call an electrician
When a switch is open (wires not connected) it is considered off. When a switch is closed it is considered on. If you move a switch and the wires are not connected the the circuit is open and current cannot run throughout the circuit to power the device.
If someone only connect one of the wires to the bulb holder, the circuit will be open and the lamp will not light. This is the same principal that a switch in the circuit does. It opens and closes the circuit.
A conductor carries the voltage potential from the source to the load, i.e. the wires from a circuit breaker to a light.
wirewound you mean? seams pretty self explanitory, wires that are wound form a mag field.
They are the wires through which current flows when the circuit is closed.
A short circuit is repaired by first finding out where the short circuit occurred. On major faults usually the wires are removed and new wires are installed. On minor faults, the wire that shorted is separated from the offending wire or separated from the grounding medium. To put the conductor back into service the wire's insulation has to be brought back to the level of what the wire was when it was new. Once that is done the circuit can be re-energized.
The standard color coding for electrical wires in a circuit is red for live or hot wires, black for neutral wires, and white for ground wires.
The color of the wires in the electrical circuit are green, black, and white.
A straight 220V circuit typically has 2 wires - one hot wire (typically black or red) and one neutral wire (typically white). These wires are used to carry the electrical current to and from the device being powered.
Neutral wires are actually ground wires. They enable the circuit to be completed.
A break in the wires of an electric current will break or cut the circuit and stop the current from flowing.
well ummm...... the circuit has metal in it to carry on the wires!
A circuit without any nonconducting wires
No, neutral wires do not carry current in an electrical circuit. They are used to complete the circuit and provide a return path for the current to flow back to the source.
wires that have got good conductivity and less losses