If someone only connect one of the wires to the bulb holder, the circuit will be open and the lamp will not light. This is the same principal that a switch in the circuit does. It opens and closes the circuit.
Assuming the wires are 2 blacks and 2 whites, and assuming one set provides power and the other set continues the circuit downline, you connect both black wires to the black wire of the lamp holder and connect both white wires to the white wire of the lamp holder. Turn the circuit off before making these connections.
With Junction boxes.
what may happen if wires are not insulated
Yes. You can twist them together and wire nut them, or solder them together.
You take a wire and stick it to the positive end of the batter. Then connect another wire to the negative end of the battery. Connect both wires to the lightbulb.
Assuming the wires are 2 blacks and 2 whites, and assuming one set provides power and the other set continues the circuit downline, you connect both black wires to the black wire of the lamp holder and connect both white wires to the white wire of the lamp holder. Turn the circuit off before making these connections.
i will tell you how if you tell me what this project is called,it uses light bulb, copper wires,holder,6 volt battery.
Spark plug wires are made in the way when it's really hard to connect wires in a wrong order, they have certain length and a special holder which prevents mistakes during repair process.
Absolutely. Only you need connect together two wires coming from each lamp holder (shunt).
plug them in
plug them in
Answer why does the person who made a circuit a probably connect the wires to a penny
Wires just connect electricity cords/outlets.
2 wires
from the wires and they connect them
On a three wire supply system if you connect the two 110V wires together and they are across the phase they will short out and trip the breaker. If the two 110V wires are supplied from across the phase and connected to a motor then the motor will run. If the 110V wires are on the same phase nothing will happen.
Connect to two wires you have to the the spade connectors and forget the ground connector. The spade connector wires should be black and white. Black to gold and white to silver. If the wires coming from the heater happen to be red and white, then red goes to black. You could buy a simple lamp cord which has only tow wires.