No, each segment of a tandem breaker is what the breaker rating on the handle states. Tandem breakers are used when there is no space left in the distribution panelboard. You get an extra circuit by removing the full size breaker and installing a tandem breaker,
For a 41 amp load, you would typically use a 50 amp circuit breaker. The general rule is to select a breaker size that is 125% of the continuous load amps or equal to the load amps if it is not a continuous load. In this case, 41 amps is considered a continuous load, so you would round up to the nearest available breaker size, which is 50 amps.
A double breaker is a breaker that has 2 switches on it. One of the switches is 20 amps and the other is 30 amps.
Depends on what you have connected to the circuit. It is less than 10 amps or the breaker would trip. A rule of thumb is you design for about 80% load related to the breaker. For 20 amps that would equal 16 amps.
breakers are rated by wire size, not voltage. the appliance manufacturer will probably specify amperage.
No the outlet holes are in parallel so the total ampacity of the receptacle is still 15 amps.
A 15 amp tandem breaker can handle a maximum electrical load of 15 amps.
For a 41 amp load, you would typically use a 50 amp circuit breaker. The general rule is to select a breaker size that is 125% of the continuous load amps or equal to the load amps if it is not a continuous load. In this case, 41 amps is considered a continuous load, so you would round up to the nearest available breaker size, which is 50 amps.
A double breaker is a breaker that has 2 switches on it. One of the switches is 20 amps and the other is 30 amps.
To calculate the total amps in a breaker panel, add up the amperage ratings of all the individual circuit breakers in the panel. This total amperage should not exceed the panel's maximum capacity, which is typically labeled on the panel itself.
Depends on what you have connected to the circuit. It is less than 10 amps or the breaker would trip. A rule of thumb is you design for about 80% load related to the breaker. For 20 amps that would equal 16 amps.
breakers are rated by wire size, not voltage. the appliance manufacturer will probably specify amperage.
KA stands for kilo-amps, or thousands of amps. Thus a 2KA breaker means it will trip when the load exceeds 2,000 amps.
The maximum amperage capacity of a Siemens breaker rated at 200 amps is 200 amps.
A balanced house panel should be the ultimate goal. It will not save you electricity as the watt meter on the house monitors the use of power from both legs of the incoming power. To balance a panel you want the current from L1 to Neutral to equal L2 to Neutral. The neutral carries the unbalanced current between L1 and L2. A perfectly balanced panel will have no current on the neutral. It is done by knowing what the current draw is on every breaker. Then they are physically positioned so that they equal each other on the opposite leg. e.g. breaker 1 on leg L1 = 5 amps, breaker 2 on leg L2 = 10 amps, breaker 3 on leg L1 = 10 amps, breaker 4 on leg L2 = 5 amps. Total up all amperages on L1 and then on L2 , if they are equal then the panel is balanced with no current on the neutral.
The total amps on the circuit exceeds 15 amps. It is possible your appliance is drawing more than 15 amps, but more likely that there are other things on the circuit causing the total current to be exceeded.
The maximum current rating for the circuit breaker is 150 amps.
The maximum current rating for a 2 pole breaker that can handle 25 amps is 25 amps.