A pilot light in a typical gas appliance burns a small amount of gas, usually around 600 to 900 BTUs (British Thermal Units) per hour.
A pilot light in a typical gas appliance burns about 600-900 BTUs (British Thermal Units) of propane per hour.
It is most likely referring to a fuse or a circuit breaker, which protects the appliance by shutting off power when there is a potential overload. This helps prevent damage to the appliance in the event of a power surge or other electrical issue.
No, it is not recommended to use a 9-volt charger for a 4.5-volt appliance. Using a charger with a higher voltage than what the appliance is designed for can damage the appliance or pose a safety risk. It is best to use the charger that is specifically designed for the appliance.
If the fuse rating is less than the current an appliance needs, the fuse will likely blow or burn out. This is because the fuse is designed to protect the appliance from overheating or catching fire by interrupting the circuit when the current exceeds the fuse rating. It is important to always use a fuse with a rating that matches the current requirements of the appliance.
No, you should not connect a 110-volt space heater to 220-volt wiring as it will likely cause the heater to burn out due to the higher voltage. You should always match the voltage requirements of the appliance to the electrical supply to prevent damage.
A pilot light in a typical gas appliance burns about 600-900 BTUs (British Thermal Units) of propane per hour.
== == == ==
You will burn up your appliance!!!!!
IT DEPENDS IF YOU PUT YOU FINGER ON IT , THEN IT CAN REALLY BURN
the appliance will burn out, eg if it is a 60 watt light bulb it will burn at 120 watt for as long as the fillament can take it and that wont be long
No, the applied 110 volt is too high for a 3 volt appliance. The appliance would burn out right away.
It depends on the efficiency rating of the burn appliance.
A typical house fire can burn at temperatures ranging from 1,100 to 1,600 degrees Fahrenheit.
Just a guess- but most have a sensor known as a thermocouple. This detects the heat of the flame of the pilot light, and keeps gas from flowing if the pilot light is not lit. check that your pilot light (a very small flame) is burning, and that the flame heats a small metal tube- about as big as a wooden match. If pilot is out, get it lit, and let burn for 5 minutes, and try lighting fireplace. If it still will not stay lit, the thermocouple may need replacement- they DO wear out. Check with your local gas appliance repair service. While they are fixing it, have them show you correct lighting process.
Burn Notice - 2007 Pilot 1-1 is rated/received certificates of: Hungary:16 (part 2) Netherlands:12 USA:TV-PG
It is most likely referring to a fuse or a circuit breaker, which protects the appliance by shutting off power when there is a potential overload. This helps prevent damage to the appliance in the event of a power surge or other electrical issue.
It will most likely be damaged beyond repair! Circuit boards will burn out as will motor/relays. And it could start a fire!