I cannot find a current listing for Teledyne Laars. As far as I can tell, Teledyne and Laars separated, Laars joined up with Waterpik and then got reorganized under Jandy. www.jandy.com now has the Laars Lite2 line of pool heaters with the LG model almost identical to the Teledyne Laars LLG. You can access the manual at http://www.jandy.com/pdfs/H02359-.pdf . Jandy also has a parts list for older discontinued models.
Possible reasons why a Teledyne Laars Phase 2 pool heater may not ignite include issues with the pilot light, gas supply, or faulty igniter. Check if the pilot light is lit, ensure there is proper gas supply to the heater, and inspect the igniter for any signs of damage or malfunction. Additionally, check for any error codes on the heater display panel that may provide further information on the issue.
Aah. It's gas. The 750mv makes more sense now. I figure you're trying to hook up the gas control valve. You should have a supply, some sort of controller, and the valve. If you wire them in series, they should work. However, I'm running off very little information. If I knew what exactly you had (As in the electric devices you are trying to wire) I could go into more detail.
Most likely one or two of the burner orifices near the pilot light are clogged making the gas travel a distance before lighting. Pull the burner tray and clean it completely. And check for spider webs and other debris in the burners. Check for other gas leaks, and don't use flex lines, flanges, valves, or other fittings inside the heater. On the Series One, check the sidewalls to make sure they are intact.
Try this link www.jandy.com Ken
go to their website and support and download it
Write or inquire thru that web site for a manual to be sent to you. k
The BTU output of a Teledyne Laars Series 2 residential heater can vary depending on the specific model. Generally, these heaters have capacities ranging from about 30,000 to 150,000 BTUs per hour. For precise specifications, it is best to refer to the product manual or manufacturer's documentation for the exact model in question.
Pool heaters are needed to help keep the pool water at a comfortable temperature. A Teledyne laars series 2 model esg pool manual is usually available with the manufacture.
You might want to try Jandy.com k
You can find every part you need for your boiler at gasboilerspareparts.com
Try google Jandy.com
Lighting this heater appears to have a number of warning messages associated with it. It is typically best to go to the source for such things, so see the link below for the manual PDF file. Look at page 29.
Use the manual provided with the heater. Each heater has somewhat different controls etc. If everything is already hooked up you may just have to turn a switch or two and turn up the thermostat.
Use the link below to look at a Laars manual to see if one is included.
Possible reasons why a Teledyne Laars Phase 2 pool heater may not ignite include issues with the pilot light, gas supply, or faulty igniter. Check if the pilot light is lit, ensure there is proper gas supply to the heater, and inspect the igniter for any signs of damage or malfunction. Additionally, check for any error codes on the heater display panel that may provide further information on the issue.