This test is the ability of one mineral to be scratched by another mineral and this is usually not done in conversion of mohs scale to brinell scale.
The hardness of St 52 steel is typically around 200-280 BHN (Brinell hardness number).
Hardness Brinell values provide information on the hardness of a material based on the indentation it makes when a predetermined force is applied. Higher Brinell values indicate a harder material, while lower values indicate a softer material. It is a useful metric for comparing the relative hardness of different materials.
The hardness of UST-36 steel is usually around 197-235 HB (Brinell hardness) or 20-23 HRC (Rockwell hardness).
A grade 2 washer typically has a hardness ranging from 80-100 Brinell. This hardness level makes it suitable for general-purpose applications where high strength is not required.
The unit of hardness is typically expressed in terms of Rockwell (HRC), Vickers (HV), or Brinell (HB) scale depending on the specific test method used. Hardness is a measure of a material's resistance to deformation or indentation.
The unit of Brinell Hardness Number is same as that for stress.
The formula to convert Vickers to Brinell hardness is: Brinell Hardness = (2.025 x Vickers Hardness).
hardness as it is measured on a rockwell or brinell testing instrument
The hardness of St 52 steel is typically around 200-280 BHN (Brinell hardness number).
Determining the hardness of materials is the purpose of a Brinell scale. The Brinell scale is one of several items used in the definition of hardness in materials science.
Mohs hardness: 6 Brinell hardness: 196 MPa.
The Brinell hardness number of brass typically ranges from 80 to 100 HB. This hardness can vary depending on the exact composition of the brass alloy and any heat treatment it has undergone.
The Brinell hardness test is a standardized test in material science. It measures the hardness of a metal by measuring the indentation on the material caused by an indenter.
Both are two different scales of hardness measurement.
The Brinell hardness tester was invented to measure the hardness of materials using an indentation. Applied force is measured against the force, diameter of indentation and indenter.
In the common Mohs hardness scale used in geology, 10 is the maximum number, the hardness of diamond. There are several other hardness scales such as Vickers, and Brinell; but these have specialist engineering (not geologic) applications. In brief, Brinell 28 would be rather soft - about that of copper. In Vickers, this number would represent something even softer - around that of gold.
Ultimate Tensile Strength is the (BHN*500)