By filtration using for ex. filtering paper.
you an use a magnet to get the iron fillings out
You need a magnet to separate iron from a mixture (not from a compound).
To separate a mixture of sugar and sulfur, you can use water to dissolve the sugar while leaving the sulfur undissolved. First, add water to the mixture and stir, allowing the sugar to dissolve completely. Then, filter the mixture; the dissolved sugar will pass through the filter paper, while the sulfur remains on the paper. Finally, evaporate the water from the collected solution to obtain the sugar.
A mixture of common salt and powdered sulfur can be separated using water. Since salt is soluble in water while sulfur is not, adding water to the mixture allows the salt to dissolve. The undissolved sulfur can then be filtered out, leaving a solution of saltwater. Finally, the salt can be recovered by evaporating the water.
Salt is soluble in water.Sulfur is soluble in carbon disulfide.Sand is insoluble.
It is very simple
It is very simple
Sulphur plus water is a nonhomogeneous mixture.
you an use a magnet to get the iron fillings out
You need a magnet to separate iron from a mixture (not from a compound).
Use a magnet.
Ammonium chloride is soluble in water, sulphur isn't. So mix the mixture with water and filter out the sulphur. Now evaporate the filtrate to obtain the ammonium chloride and permit the sulphur to dry.
The iron and sulphur split because the iron sinks and the sulphur floats so you can separate the mixture
One method of separating sulphur from a mixture of carbon particles and rolled sulphur is by using a process called sublimation. Since sulphur sublimes at a lower temperature compared to carbon, you can heat the mixture to a specific temperature where sulphur will vaporize and then condense back into solid form separately from the carbon particles. This way, you can isolate sulphur from the mixture.
To separate sulfur and sugar from a mixture, you can use a process called filtration. First, dissolve the sugar and sulfur mixture in water; then filter the mixture. The sugar will pass through the filter paper while the sulfur remains behind.
To obtain sulphur from a mixture of sulphur and iron fillings, you can use a magnet to separate the iron fillings from the mixture. Then, you can heat the remaining mixture to sublimate the sulphur, which will turn into a gas and can be collected by condensing it back into a solid form.
Sulfur is soluble in carbon disulfide.