answersLogoWhite

0

To wire a 120V A base emitter for 120V, you would typically connect the emitter to the ground, the base to the input voltage source (120V), and the collector to the load. Ensure you follow proper safety precautions and consult the specific datasheet for the A base emitter you are using for correct wiring instructions.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Related Questions

I have 240V 3 wire twistlock plug and want to wire it so I have 120V outlet?

Don't!


Which color wire is normally not on a 120v system in an apartment?

Black


What size wire is required for 120v 5amp 250ft?

Use AWG #10 wire on a 20 amp breaker.


What wire number in a 120v system L2?

In a 120V system, the wire number for L2 would typically be black (or red, blue, or another color designated for a hot wire). However, it is important to consult local electrical codes and standards to ensure compliance and safety.


You want to wire a switch to a 120V 1440W Popcorn Popper Plug is not polarized plus - which lead do you wire switch to?

Wire the switch to the hot/black lead.


Could 12 gauge wire is used on a 20 amp circuit at 120V?

Yes.


How are you losing volts by slicing a wire with 120v the going to 50v?

The voltage is lost at the slice.


What has the author Dieter Emter written?

Dieter Emter has written: 'Underground measurements at tidal sensitivity with a long baseline differential fluid pressure tiltmeter' -- subject(s): Tides, Tide-gages, Measurement


How do you wire 12V AC to 120V DC?

You would need a 12VDC to 120VAC power supply.


How can voltage increase to 240V when only 120V is coming from the breaker box?

This could occur if the 120V supply is split-phase, where two 120V lines are 180 degrees out of phase with each other. When measuring from one of these lines to the other, you would see 240V. This is a common setup in residential electrical systems in the United States.


Why do white wire mark 120v?

Because the white wire on a 120 volt circuit is the neutral wire that is connected to the silver screw on outlets and switches. It is connected to the neutral bar in the service panel.


On a 220 volt circuit where the white wire is common how many volts would the red wire be?

3 OR 4 . you only need 2 wires for 220, 1 phase is 120v between 2 of them its 220v . you also should have a ground for the third wire ,and the newer stuff requires a neutral or white wire for the 4th wire. hope i helped , D