0
What else can I help you with?
Why US use 120v and 50HZ?
The US does not use 120 volts at 50 Hertz.
How many amps in 1715 watts and 120v?
The formula you are looking for is I = W/E. Amps = Watts/Volts.
Is 12 volts dc as powerful as 120 volts ac?
You get power by multiplying the amperes and the voltage. 12V, 10A dc would give the same power as 120V, 1A ac.
Can you install a 120V baseboard heater on 110 amp power service?
Yes. The voltage of 120 volts is a nominal figure. The utility company has a plus or minus tolerance from 110 to 120 volts. This tolerance is based on the figure of 115 volts.
Why your new light fixtures dont come on when you have 120V at the socket?
My first suspicion is you have a loose or disconnected neutral. TURN THE BREAKER OFF WHEN CHECKING THE CONNECTION. To include all points, even the obvious, make sure you have changed the lamps to known working lamps from another fixture. How do you know it has 120 volts at the socket? If you tested it with a voltage tester or a multimeter, which wires were you connected to? In order to troubleshoot you need to make three measurements, at the BOXif wall or ceiling mounted or RECEPTACLE if plugged in with a cord, not the fixture socket the lamp screws into. Hot to ground (volts AC) Should be 120 volts nominal. This can vary from about 110-130v. Hot to neutral (volts AC) Should be 120 volts nominal. Neutral to Ground (volts AC) Should be 0 volts. These wires are electrically joined at your main panel. If you have 120v hot to neutral, your circuit is working properly. Any problem will lie in the fixture or the connections to the fixture. If you do not have 120v to neutral but you do have 120v hot to ground, your neutral is not connected. TURN THE BREAKER OFF and check the connection. If you do not have 120v to neutral or120v to ground, your hot is not connected. TURN THE BREAKER OFF and check the connection. If you have anything other than 0 volts neutral to ground, your fixture connection may be okay, but your neutral is not connected properly going back to the main panel. This is a dangerous situation, and it can result in fire over time. In this case have an electrician inspect the situation immediately!
What should voltage be at socket of a 400w hps fixture 120v?
100 Volts
Why US use 120v and 50HZ?
The US does not use 120 volts at 50 Hertz.
What ohm value or what combenation of resistors are needed to draw 20amps at 120v?
ohms = volts/amperes 6 ohms = 120 volts / 20 amperes
What is the voltage of a series circuit with four voltage drops of 30 volts?
there is 120V across the circuit.
How many watts in 120v-60Hz-12A?
To calculate watts, you can use the formula: Watts = Volts × Amps. For a 120V, 60Hz, 12A circuit, it would be: 120V × 12A = 1,440 watts. Therefore, the circuit uses 1,440 watts.
What is the Amps for 1KVA?
For a 1kVA (kilo volt-ampere) load at 120V, the amperage would be approximately 8.33A (1000VA / 120V). This calculation is based on the formula: Amps = VA / Volts.
How many amps in 1715 watts and 120v?
The formula you are looking for is I = W/E. Amps = Watts/Volts.
What is the voltage drop of a series circuit with four voltage drops of 30 volts?
there is 120V across the circuit.
How many amps is 9.8Kw?
To calculate the number of amps, you need to know the voltage of the circuit. Using the formula Amps = Watts / Volts, if the voltage is 120V, then 9.8kW at 120V would be approximately 81.67 amps.
Does an electric stove burner use 220 or 110?
The burners will most likely be 240V. By keeping the range at 240 volts it will use less amps that at 120V. Say a range and oven is rated at 9000 watts. Watts = amps x volts. 9000/240V = 37.5 amps. 9000/120V = 75 amps. As you can see at 120 volts the amperage is double over 240 volts. You would need a 100 amp breaker and #4 wire to accomodate the range on 120 volts.
Is 12 volts dc as powerful as 120 volts ac?
You get power by multiplying the amperes and the voltage. 12V, 10A dc would give the same power as 120V, 1A ac.
What is the standard voltage in Alberta Canada?
Household is 120/240 volts at 60Hz. The average wall socket is 120v 60Hz.
