Depends on type of plug and where it's supposed to go.
A polarized plug can only fit together in one direction. This is to prevent reverse polarity in the device you are plugging in.
No, the wide prong is neutral it is the white wire. The narrow prong is hot it is the black wire. The round prong (in a 3 wire plug) is safety ground it is the green wire.
To convert a 3-wire plug to a 2-wire plug, you would typically remove the ground wire from the circuit. This is not recommended for safety reasons as the grounding wire serves to protect against electrical shocks. It is safer to use a 3-to-2 prong adapter if you need to plug a 3-wire device into a 2-wire outlet.
The number 1 plug wire on a 454 Chevy engine typically connects to the spark plug located in the front-left (driver's side) cylinder. You can refer to the firing order diagram for your specific engine to ensure the correct placement of the plug wire.
To wire a 3-wire appliance to an L14-20 plug, connect the green ground wire to the ground terminal, the white neutral wire to the silver terminal, and the black or red hot wire to the brass terminal. Make sure to follow proper safety precautions and consult a professional electrician if you are unsure of the wiring process.
Spark plug wire not connected to spark plug? Spark plug wire connected to Wrong spark plug? Vacuum line disconnected? Bad spark plug or wire?
In a 2-pin plug, the wire that is not present is the grounding wire. This type of plug only has two prongs for the live and neutral wires, unlike a 3-pin plug that includes a grounding wire for added safety.
bad spark plug wire.
propaly farmers
I need a lot more information. I don't know what you mean by four wire plug. What does it look like, what was it used for? What three wire plug are you installing, what does it look like, what is it used for. What color ore the wires?
to the furtherest plug! Plug #1 is probably the longest wire
how to replace plug wire on a toro mower
If it is the same plug every time, I would say the plug or wire is grounding out some where. Try replacing the plug the the wire.
A 2-pole wire will not work on a 3-pole plug. You will need to use a 3-pole wire on a 3-pole plug.
Change the cord/plug on the stove to a four wire cord/plug. When installing the new plug remove the grounding strip that connects the center lug in the stove wiring block to the frame of the stove. Connect the white wire from the new plug to the center lug. Connect the green wire from the plug to the stove frame.
i have a metal sleeve over each spark plug wire at the motor.....cant get the wire out to get to the plugs?? how do i get the wire off the plug??
If you mean that the wire came out of the boot, then pull the boot off of the spark plug and use a spark plug socket to remove the spark plug.