Depends. Some smaller stuff can usually run on both, in which case it will be printed on them. If it isn't, you can't run a 220v item on 110v.
Connecting a 220V appliance to a 110V power source can damage the appliance and potentially cause a fire. The appliance is designed to run on 220V input, so using a lower voltage can overload its components. It's important to use the correct voltage to ensure safe and proper operation.
If you mean - can you run a 220v device on 120v where the 220v device needs that level of voltage to operate correctly then the answer is no. Even disregarding the frequency difference which some devices aren't affected by, the voltage difference is too great. Some devices these days, such as phone chargers, laptop power supply units etc will run happily on a voltage range from 100v up to 240v (read the label first) but they are the exception. The question is somewhat ambiguous and needs more information.
If all the components are rated to 220V, yes. Keep in mind that if the appliance was designed for 110V it may arc if 220 is run through it. If you don't know the device can handle 220V, don't run it at 220V. Chances are it was manufactured cleaply and cannot handle the extra voltage.
The normal voltage of house electricity in Korea is 220 volts. This voltage is used for powering household appliances and electronic devices throughout the country.
Yes no problem the transformer should run a little cooler as well.
Depends. Some smaller stuff can usually run on both, in which case it will be printed on them. If it isn't, you can't run a 220v item on 110v.
45
No
No. Attempting to run an appliance on insufficient voltage can cause damage to the appliance and can be dangerous. Call an electrician and get him to install a 220v plug
Short answer: No. (unless you like ruining motors) Longer answer: Not really, but there are some motors that can be re-wired so that instead of 440v they will run on 220v. However, this is not that common. Conclusion: Check the motor to see if it is dual-voltage on it's nameplate. If it is, you can re-connect it to work on 220v. If it is NOT a dual-voltage motor, you will absolutely ruin it if you connect it to 220v.
No, the compressor& fan will run too fast and will more than likely be damaged. It may not be damaged but I would not take a chance.
Unless the computer has a switch on the back allowing you to use both dual voltages and frequencies, the computers internal clock will run faster.
A "dead run" just means you were running as hard as you could. You were really running as you left home.
No.It'll overload and fail just about immediately.It's possible - but not recommended - to run two 110 v heaters in series from a 220v circuit.
Most 220 volt equipment will work on 208 volt supply. If the machine has a resistive load then the watts output will be lower than if supplied from a 220 volt source. If it is a motor load you will find that the equipment may run a bit slower but most motors will take the lower voltage. If the machine is a plug in device, install the appropriate receptacle to match the pin configuration and plug it in. If it is a hard wire installation this should be done by a qualified person.
For the same power - Watts - you need to run twice as many amps at 220V than at 440V. For the same load, it'll pull half the amps at 220V than it did on 440V