It depends.
The Wattage ratings do not indicate how bright any type of bulb is, just what its power consumption is.
In general LED lamps put out more light for the power used than metal halide bulbs, but there is no standard as to how much more. Most lamps indicate their candlepower or 'candela' ratings on the package, and the vary by type of bulb and manufacturer.
The 'candela' is the SI base unit of luminous intensity.
Metal Halide lamps produce many more ANSI lumens than an LED lamps. However, given this fact, many manufacturers are focusing their production on LED technology because they produce light that lasts 4 to 10 times longer, and they do not get hot like metal halide lamps.
LEDs and CFLs use about a quarter of a halogen so the answer is 35-40 watts.
There is no direct conversion between lumens and watts for LEDs since they are measured differently. However, as a rough estimate, a 60-watt incandescent bulb produces about 800 lumens. For an equivalent LED output, you would typically need an LED bulb with around 800 lumens.
It depend on what the rating voltage of the LEDs are.
The available color of LEDs are infrared, red, yellow, green, white, orange, blue, violet, ultraviolet and purple.
Metal Halide lamps produce many more ANSI lumens than an LED lamps. However, given this fact, many manufacturers are focusing their production on LED technology because they produce light that lasts 4 to 10 times longer, and they do not get hot like metal halide lamps.
LEDs do not contain the toxic metals found in HPS (High Pressure Sodium) and MH (Metal Halide) lamps! That's less hazardous waste to deal with, allowing for easier recycling and safer disposal. for more info and lights come to tacticallight.com
LEDs come for different power ratings. Miniature LEDs use between approximately 40-90 mW. High-power LEDs - used for illumination - can use hundreds of watts per square centimeter.
Watts are a unit of power. So 40 watts of power to an LED are the same as 40 watts of power to a fluorescent. Sometimes LEDs are rated in equivalent watts which is an attempt to relate watts to brightness or lumens. You need to compare lumens and the "temperature" of the bulbs in Kelvin to get the comparison I think you are looking for.
A: ROPE lights are not LEDS but rather incandescence bulbs using 16 Watts per foot
Are you talking about the brake lights? You cant replace any LEDs, you just have to replace the carrier of which ever assembly is out.
LEDs and CFLs use about a quarter of a halogen so the answer is 35-40 watts.
not enuff information 20 leds in parallel at 2.5v about 2W a motor at 480V 3 phase 600 w or 3/4 hp
If your compairing apples to apples like 3 watt leds to 3w leds then 128. The more leds the higher the power.
Depending on the length, between 30 and 60 Watts of power for fluorescents and around 10 Watts for LED T8'sHeat is negligible for the LEDs, and almost negligible for Fluorescents*exact numbers not available at the moment.
Yes, LEDs are dimmable.
Basically, when LEDs are connected in parallel, the LEDs with the lowest resistance will be the brightest, the other LEDs will be dimly lit or not lit at all. Therefore, use LEDs with the same model number and colour.