Since you didn't say quarts of what. Engine, W/ OOP with filter..........5.9 qts
Engine, W/O OOP with filter..........5.0 qts
Cooling System, with AC Initial Fill..........20.0 qts
Cooling System, W/O AC Initial Fill..........17.0 qts
Automatic Transmission, 4L80E Initial Fill.....7.7 qts[1]
Automatic Transmission, 4L60, 60E Initial Fill 5.0 qts[1]
Automatic Transmission, Total Fill
4 speed 4L60E..........11.0 qts
4 speed 4L80E..........14.0 qts
Differential, with 10.5 ring gear EX Dana Rear....6.3 pints
Differential, Front..........3.6 pints
Differential, with 10.5 ring gear Dana Rear....5.5 pints
Differential, with 12 ring gear Rockwell Rear....14.0 pints
Differential, with 8.5, 8-5/8 ring gear Rear....4.2 pints
Differential, with 9.5 ring gear Rear..........5.5 pints
Differential, with 9.75 ring gear Rear..........5.5 pints
Transfer Case,NVG 236/246..........4.0 pints
Transfer Case,NP241/NP243..........4.4 pints
Transfer Case,NVG 149..........4.9 pints
Transfer Case,NVG 261/263..........4.0 pints 1. With the ENG at operating TEMP, shift TRANS through all gears. Let ENG slow idle in PARK for at least 3 minutes. Check fluid level and add fluid as needed. Do not overfill.
Your units must be consistent, so convert the gallons to quarts. When both measures are in the same units, you can figure it out easily using subtraction. Hint: There are four quarts in one gallon.
Common customary units used to measure volume include fluid ounces, cups, pints, quarts, and gallons in the United States. Imperial units such as fluid ounces, pints, quarts, and gallons are used in countries that follow the British imperial system.
34 US quarts contain a total of 32,176 milliliters. If each milliliter contains 45 micrograms, then thirty-four quarts will contain approximately 1.44792 grams of lead, though some portion of this will likely be lost if processes are used to extract it.
No, it is not part of the metric system. A quart is equivalent to .95 liters.
Clear Quarts can be found in the continental crust and are found in huge abundance in Europe. They are also found commonly in the Middle East where this is one of the most commonly used mineral in the area.
Dexron-III Automatic Transmission Fluid
i have an SE and it takes 6 quarts. ford now recommends 5w-30
6.0 quarts with engine oil filter change , according to the Owner Guide
According to the 1999 Ford Explorer Owner Guide : With engine oil filter change : The 5.0 liter V8 engine takes ( 5.0 U.S. quarts of 5W-30 )
Filter change, about 5 quarts Dry fill, about 9 quarts.
According to the 1999 Ford Contour Owner Guide : With engine oil filter change : The 2.0 liter four cylinder engine takes ( 4.5 U.S. quarts of 5W-30 ) The 2.5 liter V6 engine takes ( 5.8 U.S. quarts of 5W-30 )
Quarts is used to measure liquid volume.
With engine oil filter change ( 4.5 quarts ) according to the Owner Guide
what type of engine oil is used in a 1999 ford expedition -------------------------------------------------------------------------- 5 W 30 ( with filter change - 6 quarts / 5.7 liters )
Two and a half quarts.
i believe it is about 8 quarts to flush and fill the system. i believe it is about 8 quarts to flush and fill the system.
The CD4E automatic transaxle found in the Cougar, Contour, Mystique, Focus, Escape, and Escort vehicles used 6.9 quarts. The MTX-75 transaxle used 2.1 quarts.Source:FocalJet->Zetec tuning->Basic Info & Problems: Tuning the Zetec