Sublimation of camphor occur faster by heating and sand remain.
To separate camphor from a mixture of sand and camphor, you can use sublimation. Heat the mixture gently so that the camphor sublimes (changes from solid to gas) and then reverts back to solid form on a cool surface. The sand will remain behind as a residue, allowing the separation of camphor from the mixture.
The fertilisers can be separated by the process of filteration.
You can separate sand from water using the process of sedimentation and decantation. Allow the mixture to stand so that the sand settles to the bottom of the container. Carefully pour off or decant the water, leaving the sand behind.
To separate sugar and sand from water, you can use the process of filtration. Pour the sugar and sand mixture through filter paper or a fine sieve to capture the solid particles, while the water passes through. The sugar and sand can then be rinsed with more water to further separate them.
No, separating sand from water by filtration is a physical process, not a chemical reaction. This process involves passing the mixture through a filter to physically separate the solid particles from the liquid.
Sublimation
To separate a mixture of iron filings, sand, and camphor, you can use a magnet to attract the iron filings, leaving the sand and camphor behind. Then, you can dissolve the camphor in water as it is soluble, allowing the sand to settle at the bottom. Finally, you can filter out the sand to obtain separate components.
To separate camphor from a mixture of sand and camphor, you can use sublimation. Heat the mixture gently so that the camphor sublimes (changes from solid to gas) and then reverts back to solid form on a cool surface. The sand will remain behind as a residue, allowing the separation of camphor from the mixture.
Camphor is a volatile solid i.e. its vapour pressure becomes equal to the atmospheric pressure much below the melting point. But, common salt is non-volatile. Hence, camphor may be very easily separated from common salt by a physical process, SUBLIMATION! props to yahoo answers
One way to separate naphthalene from sand is by sublimation. By heating the mixture, the naphthalene will undergo sublimation, turning into a gas and leaving behind the sand. The gas can then be collected and cooled back into solid naphthalene.
To separate the mixture, you can use a magnet to attract and remove the iron filings first. Then, you can add water to the remaining mixture, as sand will sink and camphor will float. By decanting the water, separated sand and camphor can be obtained.
One method to separate iodine crystals from a mixture of iodine and sand is by using sublimation. Heat the mixture, and the iodine will sublimate (turn into gas) leaving the sand behind. The iodine gas can then be collected and cooled to form iodine crystals.
Take a magnet to get the iron out.Blow the poppy seed out with wind blowing or vacuum cleanerDissolve the benzoic acid in pure alcohol (solubillity max. 2.6 M), filter off.Dissolve the salt in warm water, filter off the 'left-over' sand.(it is possible to reverse the last to steps, but then it is more difficult to evaporate the 'benzoic acid'-tincture, after its final filtration, there will be also some salty water -from the previous step- dissolved in it)
To separate iodine from sand, the mixture can be dissolved in water since iodine is soluble in it, while sand is not. Once the iodine is dissolved, the solution can be filtered, leaving the sand behind on the filter paper. The iodine can then be obtained by evaporating the water from the filtered solution.
One suitable technique to separate sand from ammonium chloride is filtration. The mixture can be dissolved in water, allowing the ammonium chloride to go into solution while the sand remains as a solid. The solution can then be passed through a filter to separate the sand from the dissolved ammonium chloride.
Sublimation can be used to separate naphthalene from sand. Naphthalene can be heated to change it directly from a solid to a gas, leaving the sand behind. The gas can then be collected and cooled to form solid naphthalene again.
The fertilisers can be separated by the process of filteration.