Specimen collection can be identified by labeling each specimen with patient information, date and time of collection, and type of specimen. The specimen should be collected using proper techniques, stored in appropriate containers, and transported to the lab in a timely manner to maintain specimen integrity. Accurate documentation of the entire collection process is important for proper identification.
gneiss is the answer
The student should adjust the condenser to allow more light to pass through the specimen in a compound light microscope. By adjusting the condenser height or iris diaphragm, the amount of light reaching the specimen can be controlled for better visibility.
There is no single temperature. It depends on the nature of the specimen.
The high power objective should be used when you need to examine smaller details or structures in a specimen at higher magnification. It provides a higher magnification level compared to the low power objective, allowing you to see finer details.
A smear specimen should be fixed by air-drying the sample or by heat-fixing the slide. This helps to preserve the cellular morphology and prevent degradation of the sample during staining and observation under a microscope. Fixation also improves the adherence of the cells to the slide, making it easier to analyze the sample.
The specimen should be placed on the top surface of the microscope slide. This allows the light to pass through the specimen from below and be magnified by the lenses in the microscope to form an image for observation.
If a specimen spills on your clothes, you should immediately remove the contaminated clothing and wash the affected area with soap and water. Be sure to follow any specific handling instructions for the type of specimen involved and seek medical advice if needed.
When viewing a specimen under the microscope, you should always start with the lowest magnification objective lens. This allows you to locate and focus on the specimen before moving to higher magnifications for a closer look.
No, when using a microscope, you should focus away from the specimen initially by moving the objective lens upward, then slowly bring it down towards the specimen to avoid damaging the lens or the specimen.
so see the should you want to see
As much as necessary.
Specimen collection can be identified by labeling each specimen with patient information, date and time of collection, and type of specimen. The specimen should be collected using proper techniques, stored in appropriate containers, and transported to the lab in a timely manner to maintain specimen integrity. Accurate documentation of the entire collection process is important for proper identification.
Because it will change shape as it dries, so mounting it while it is wet would cause excessive stresses.
When you are at the doctors office.
low power objective lens to locate and focus on the specimen before moving to higher magnifications.
he should get fixed