answersLogoWhite

0

To ground a Vossloh Schwabe ballast, first ensure that the power is disconnected. Then, connect the grounding wire from the ballast to a suitable grounding point, such as a grounding screw or a metal chassis. Make sure the grounding connection is secure to prevent any electrical hazards.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Continue Learning about Natural Sciences

How do I wire a 220v ballast when it has only 1 wire labeled 220 when I have 2 wires coming off of my double leg breaker?

Your ballast should show two wires for supply side of ballast. Make sure that neither side of this is grounded to the light and connect the 220 V from your breaker to these two wires and then connect a ground to the chassis of the light from the panel.


How to connect ballast?

To connect a ballast, first, ensure the power is turned off. Then, match the wiring from the ballast to the wiring in the fixture according to the wiring diagram provided with the ballast. Make sure all connections are secure and insulated properly before restoring power.


Can T8 LED tube light be used with ballast and can ballast be removed and will it work?

A T8 LED tube has to be used with a ballast to bring the correct voltage to the tube for it to operate correctly. Removing the ballast from the circuit will prevent the tube from operating.


How do you wire a 4-lamp electronic ballast?

The way a metal halide light is set up, there's a transformer in it called a "ballast." The ballast powers the bulb. You can wire ballasts to a lot of different voltages--which voltages you can use are dependent on the ballast in question--but 120v single phase is almost always one of the choices. So yes, you can do it.


Why does your fluresant light not work after you installed a ballast?

Do you have the right ballast for the type of lamps you are using? Check on the nameplate of the ballast to see it matches with the type of tubes you are using. Are the tubes snug in the lamp holders? Is the fluorescent fixture grounded using the fixture ground screw? Do you have voltage to the ballast? On most lamp start ups you can see the lamp filament glow on each end of the tube. If you don't see the filament glow on any of the tube ends, check the wires going to that lamp holder.