The volume, in this case, will reduce by a factor of 4 (i.e., to 1/4 of its previous volume).
1 ml solute to 19 mls solvent. This gives a total volume of 20 (20 fold)
There is a 1,000-fold decrease in H+ concentration when the pH increases by 3 units (pH 4 to pH 7). This is because the pH scale is logarithmic, so each unit change represents a 10-fold change in H+ concentration.
It's called the square-cube law. If an object (such as a cell) increases in size [say doubles] then its volume (or mass) goes up by the cube of the size, but its surface area increases only by the square of its size. Thus a doubling will produce a 4 fold increase in surface but an 8 fold increase in mass. Since cells depend on diffusion of molecules through its surface, it can outgrow its ability to acquire new materials (or to get ride of waste. This rule also limits the size of insects (actually all animals).
Using Boyle's Law (P1V1 = P2V2), we can rearrange the formula to find the new volume: V2 = (P1 * V1) / P2 V2 = (1 ATM * 2.4 L) / 6 ATM V2 = 0.4 L Therefore, the gas will occupy a volume of 0.4 L at 6 ATM.
The force that changes the shape and volume of rocks is called deformation. This can occur due to stress from tectonic forces, such as compression, tension, or shearing, causing rocks to bend, break, or fold.
The pressure of the balloon increases threefold when it is squeezed to one-third its volume with no change in temperature. This is because pressure is inversely proportional to volume according to Boyle's Law, which states that when volume decreases, pressure increases.
The volume increases 27-fold.
The volume becomes eight-fold.
It increases 8-fold.
If linear dimensions are increased by a certain factor, the volume will increase by that same factor, raised to the third power - so, in this case, 3 to the power 3.
It increases nine-fold.
If the length of the sides triples, the surface area increases 9-fold.
When rock layers are folded, a geological fold happens. These folds form under various conditions such as stress, hydrostatic pressure, pore pressure, and temperature gradient.
The solubility of silver chloride increases five fold upon heating to 100°C.
This is the reduction of volume to one-third.
1 ml solute to 19 mls solvent. This gives a total volume of 20 (20 fold)
It hurts?