No, an external antenna can work without electricity. It simply picks up radio frequency signals from the air and sends them to the device it is connected to. The device, such as a TV or radio, uses its own power to process and display the signals.
Aluminum ore is called bauxite. All you need to make aluminum is bauxite and a hell of a lot of electricity.
Electricity is needed to extract aluminum and titanium from their ores through a process called electrolysis. In this process, electricity is used to break down the chemical bonds in the ores and separate the pure metals from their compounds. This is a crucial step in the production of aluminum and titanium.
External fragmentation describes the situation where free memory blocks are scattered throughout the memory space, which can make it challenging to find contiguous blocks of memory for larger programs or data. This can slow down the memory allocation process and waste memory resources. Techniques such as compaction or paging are used to reduce external fragmentation and ensure efficient memory utilization.
some forms of energy that can make electricity are but not limited to Water, Wind and Solar power ...
A battery can be used twice a day to make electricity by discharging and recharging it.
The external antenna broke off the car.
If you do not see an external antenna, then it is in either the front or rear windshield. Look closely and you will see the tiny wires that make up the antenna.
There are many places to purchase a cell phone antenna from. Here is one site that I found that is currently having a sale: http://www.antennabooster.net/. Alternatively, you can even make your own if you are so inclined! This video explains how it can be done: http://www.wonderhowto.com/how-to-make-external-antenna-for-your-cellphone-185772/
Many chemicals are needed. Electricity and raid are typically neither.
Cell phone antennas have changed in many ways over the years since cell phones were first introduced. When first introduced, cell phones needed to have external antennas to be able to pick up signals from service towers. However, over time external antennas seemed somewhat out of fashion, so as cell phone designs evolved the external antenna became an internal antenna. Although many internal antennas work very well, there have been some problems concerning signal reception. Generally speaking, although external antennas are out of style and can make your phone feel somewhat bulky, external antennas are still one of the most practical ways to have your cell phone receive a good, strong signal.
In a theoretical ciucuit, a switch is not essential. What is needed is a source of electricity.
You don't.
unplug the electrical from the antenna. replace antenna.
Of course you can. It is probably a bigger project than you would want though. You may have to remove a fender or at least the plastic fender liner to get to the top of the fender close to the cowl. After drilling a hole in the fender to mount the antenna you will have to make a hole into the passenger compartment to run the wire in to the radio. Lots of opportunities to make a mistake.
There are three main properties that make electricity work: voltage, current and resistance. Toys are controlled by Radio active element such transmitter, receiver, motor, power source and antenna.
There are only 2A coil of condutor wireA flow of electricity in that coil of wire.
none, electricity keeps on dying and so the ellectricity of the world is unfortunatly becoming extinct and so we are all reading the Indians myths on what happened to make electrictiy die so often.