Shaking when you let off the gas could be due to issues with the engine mounts, transmission mounts, or a misfiring engine. It is recommended to have the vehicle inspected by a mechanic to diagnose and address the underlying issue.
Turning off the Bunsen burner at the gas tap puts out the fire because the gas is a switch that lets the amount of gas that you want to burn. And if you turn it off then it would let no gas through and there for would not let the Bunsen burner light up. Hope this helps
To turn off a Bunsen burner, first close the air hole at the base of the burner by turning the metal collar clockwise until it's fully closed. Then turn the gas knob on the burner clockwise until it stops to shut off the gas supply. Let the burner cool down before handling it.
A loud squealing noise when giving gas and letting off could indicate a worn drive belt or pulley issue. It could also suggest a problem with the power steering system or a loose belt. It's best to have a mechanic check and resolve the issue to prevent further damage.
The flame goes out because you turned it off.
If the gas is not turned off first, on removing the tubing, gas will escape - very dangerous.
When that happened to my car it was the axel.
Halogen fluid. When it gets low this can happen.
Most likely a motor mount. Or axle shaft.
you need a front end alignment
Your car is not getting enough fuel if it hesitates to take off and shakes. The fuel filter might be plugged or you might have the wrong gas in your tank.
Check the fuel pressure......
My whole truck vibrates when accelerating and it stops when I let off the gas. It shakes really bad over 20 mph and continues as I speed up. It is in the repair shop now for a new U joint.
let off the gas let off the gas
Have the torque convertor clutch in the trans checked out for slippiing.
94 astro will only start if the gas peddle is to the floor and it sounds really rough ,it stalls as soon as you let off the gas
Turn in the direction of the skid and let off the gas.
U joint