Yes go to autozone they can provide the correct bulbs.. They are a little tricky to take out you have to disassemble the dash..
You probably blew the breaker for the lights. While usually the lights and outlets in a room are on the same breaker, it isn't always done that way. And you may have blown the light bulbs in the lights.
The most common problem is switch on side of transmission.(If bulbs and fuse are good) Another common problem with reverse lights is a faulty ground. Check for the black ground wire off the lights in the back. If the connection to the ground (body or frame) is rusted or broken repair it.
Flickering lights in a mobile home bathroom could indicate a loose connection in the electrical wiring, faulty light fixture, or a problem with the electrical panel. If the plug-ins are still working, the issue may be isolated to the bathroom circuit. It is best to consult with an electrician to diagnose and fix the problem to ensure safety.
Aluminum wiring in mobile homes often causes this problem. Also loose or corroded connections could be the cause. Power company transformer wire connections also corrode which can cause the problem. This is a potential fire hazard and should be checked immediately by a licensed electrician.
you fix the light on the ceiling fan by puting a new light bulb in your fan
Check dimmer switch.
Flickering lights in your house can be fixed by checking for loose bulbs, faulty wiring, or a problem with the electrical panel. You may need to tighten the bulbs, replace them, or call an electrician to inspect and repair any wiring issues.
Could be the bulbs or the fuses or the flashers or the signal switch assembly
Your first place to look would be the fuse panel. If everything there is ok, you'll probably have to remove the gauge panel and check the bulbs there.
Fuse, brake switch, bulbs. Replace whatever the problem is. There is no way to know without being hands on. Bulbs most likely answer.
check the bulbs themselves they sometimes short out internaly & cause feedback also check sidemarker lights I have changed all bulbs and fuses! Wiring problem???
how can i fix lic plate lights not working when bulbs and fuse are good?
i have dash light problems also and my easy fix is just hitting the dash . the lights all work again after i do!
your instrument panel lights can be dimmed(thumb wheel switch) down to practically no lights at all on your instrument cluster, this switch should be located most likely on the dash, left hand side of steering column. If this does not fix the problem ,then you have to check your fuse panel to see if you have a burnt out fuse.
Thr panels can not be repaired It needs a tailight PPPSSttt...There may be a recall for this coming in the near future
Check the brake light bulbs, Check the brake light fuse, Check the brake light switch, In that order.
check a page or two back,there's an answer. mine did the same thing and the flasher was just loose.