It depends on context. If the potential difference is an electromotive force, then it's symbol is usually E. For all other potential differences (e.g. voltage drops), the symbol is usually either V or U (with the latter symbol used throughout Europe). Symbols for quantities, such as these, are italicised.
With alternating-current circuits, upper case letters (E, V, U) are used to represent peak or r.m.s. values, whereas lower-case letters (e, v, u) are used to represent instantaneous values.
a voltmeter is used to measure voltage
A potentiometer is a variable resistor, while a voltmeter is a device that measures voltage.
A common symbol used for comparison is the equal sign (=). This symbol is used to indicate that two values are equal to each other.
"N/A" is commonly used as the symbol for "does not apply" in forms or documents.
A transformer can be used, either a step-up or step-down transformer, to deliver the power at a different voltage from the normal supply voltage.
a sine wave (~)
The symbol 'u' is often used in place of the prefix 'micro-' in math and physics.AnswerThe symbol U is used to represent voltage. In this context, a lower-case 'u' represents an instantaneous AC voltage. In thermodynamics, it is used to represent internal energy.
The symbol used for amperage in formulas is the letter "I", for voltage "E" for watts "W". The formula for watts is W = I x E.CommentThe symbol for electric current is I; the symbol for ampere is A. The symbol for voltage is E, V, or U, depending upon context, and the symbol for volt is V. The symbol for power is P, and the symbol for watt is W.
The symbol is actually a letter. The original letter was an E which stood for Electromotive force. Now-days the E is substituted by the letter V which of course stands for voltage.
V
The symbol V stands for voltage.
The symbol for electrical volts is "V". <<>> The symbol for voltage is the letter E. It stands for Electromotive force known as EMF.
rail way gates
E = Voltage drop V = Voltage
Voltage is not "used" Voltage is constant.
The most common symbol used for DC voltage is two, short, parallel horizontal lines, only the bottom one is dashed. Click here for an image: http://upload.wikimedia.org/wikipedia/commons/9/9f/Direct_current_symbol.svgAnswerThe ISO recommends lower case letters as follows: d.c., except where it is used at the start of a sentence, where it should be capitalised: D.C. For example:"A voltage of 12 V d.c.""D.C. voltages are supplied by batteries."
Voltage = Current x Resistance is often written V = I x R. Ohm's Law is: E = IR E is voltage