water dissolves ALL ionic and ALL polar compound's;
examples of each are;
Polar compound's,
ethanol, ammonia, Hydrogen Fluoride, sulphur dioxide, acetone
Ionic compounds,
sodium chloride
potassium chloride
lithium chloride
rubidium chloride
cesium chloride
Not, but water will. If you need something that mixes with common petroleum products mix 1 part ajax dish soap with 5 parts water, 10 parts isopropanol. Use sparingly.
Increasing the temperature of the solution allowed more of the solute (NO3) to dissolve due to an increase in solubility. As temperature increases, the kinetic energy of the solvent molecules also increases, making it easier for the solute molecules to break apart and dissolve. At 55°C, the solubility of the compound was high enough to dissolve the extra 5 grams that initially settled out at 25°C.
H2O2 has four nuclei (atoms) in one molecule. Therefore, it has 20 'atoms' in 5 molecules. H2O has three nuclei in one molecule. Therefore, there are 15 nuclei in 5 molecules of water. 20-15 = 5 Ans: 5!
The minimum amount of water required to dissolve 5 grams of magnesium sulfate would be approximately 72 mL at room temperature (25°C).
CuSO4 · 5H2O has 5 water molecules attached to each CuSO4 molecule.
Yes, water readily dissolves most polar compounds because water is a polar molecule itself, having a partial positive charge on the hydrogen atoms and a partial negative charge on the oxygen atom. This polarity allows water to form hydrogen bonds with other polar molecules, facilitating their dissolution in water.
generally nonpolar. Organic compounds that are poorly soluble in water are usually nonpolar or have very weak polarity, which makes it difficult for them to form interactions with water molecules. This lack of polarity hinders the ability of the organic compound to dissolve in the polar water molecules.
Not, but water will. If you need something that mixes with common petroleum products mix 1 part ajax dish soap with 5 parts water, 10 parts isopropanol. Use sparingly.
yes, an m&m will dissolve faster in hot water, because the heat from the water will speed up the molecules in the m&m, and cause it to dissolve faster than it would under cold circumstances.
Increasing the temperature of the solution allowed more of the solute (NO3) to dissolve due to an increase in solubility. As temperature increases, the kinetic energy of the solvent molecules also increases, making it easier for the solute molecules to break apart and dissolve. At 55°C, the solubility of the compound was high enough to dissolve the extra 5 grams that initially settled out at 25°C.
"Like dissolves like" This is simply stating that a solute will dissolve best in a solvent that has a similar polarity to itself. For example, a very polar (hydrophilic) solute such as NaCl is very soluble in highly polar water and and practically insoluble in non-polar solvents such as benzene. However, a non-polar (lipophilic) solute such as carbon dioxide is insoluble in water and highly soluble in non-polar benzene. For a non-polar solute such as carbon dioxide to become more soluble in water, the pressure of the system would have to be increased. This is why most sodas are under 5 atmospheres of pressure.
for each mole of anything there is 6.022x10^23 molecules. Therefore for 5 moles of water there is 5 x 6.022x10^23 = 3.011x10^24 molecules of water
It takes about 5 seconds.
100ml
Salt dissolve quicker in hot water because it practicaly melts the salt there fore making it quicker.
H2O2 has four nuclei (atoms) in one molecule. Therefore, it has 20 'atoms' in 5 molecules. H2O has three nuclei in one molecule. Therefore, there are 15 nuclei in 5 molecules of water. 20-15 = 5 Ans: 5!
DNA is a polar molecule because it has a negatively (-) charged phosphate group attached to the 5' end of the molecule and a negatively charge hydroxl group (OH) attached to the 3' prime end of the molecule.Thus, it is a POLAR molecule which allows it to interact in an aqueous environment.