answersLogoWhite

0

Those are called brushes. They are used to conduct electric current between stationary wires and rotating parts in an electric motor or generator. The brushes are typically made of carbon or metal alloys to ensure good electrical contact and minimize wear on the commutator.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Related Questions

What are the springy pieces of metal or carbon that make contact with the commutators contacts in an electromagnet?

brushes


In an electromagnet what are the springy pieces of metal or carbon that makes contact with the commutators contacts?

brushes


In an electromagnet what are the springy pieces of metal or carbon that make contact with the commutators contacts?

These springy pieces are called brushes. They conduct current between stationary wires and moving parts in the electromagnet, ensuring continuous contact with the commutator's contacts as it rotates.


In an electromagnet what are the springy piece of metal or carbon that make contact with the commutators contact?

brushes


In an electromagnet what are the springy pieces of metal or carbon that make contact with the commutator's contacts?

The springy pieces of metal or carbon that make contact with the commutator's contacts in an electromagnet are known as brushes. Brushes are responsible for delivering electrical current to the commutator, allowing the electromagnet to function as intended.


What are the springy pieces of metal or carbon that make contact with the commutator's contacts?

It's a small block of graphite. The graphite acts as both the electrical contact to the commutator and as a lubricant to reduce drag and wear.


Why is graphite suitable for making carbon contacts?

Graphite is suitable for making carbon contacts because it is a good conductor of electricity, has low resistance, and is chemically stable. Its layered structure allows for easy transfer of electrons, making it ideal for use in electrical contacts.


Why athletes use carbon fiber limbs?

Most of them don't. But carbon fibre has a good strength-to-weight ratio and is real springy. If you're an athlete who has lost your own limb, carbon fibre is probably the way to build the best performing prostethic.


What is an alternative to carbon brushes in an ac motor?

An alternative to carbon brushes in an AC motor is using a brushless motor. Brushless motors have permanent magnets and electronic drive systems to operate, eliminating the need for brushes or commutators. This design results in less maintenance, higher efficiency, and longer lifespan compared to motors with carbon brushes.


Why would the turn signal socket melt on a 1998 century?

I think it could be due to geometrical shape of the electrical contact at the socket or housing If the contacts are in an arc shape, it might reduce the surface contact to a very narrow point which will overheat by lack of material for heat dissipation. the overheat situation will create a spark at the contact which will create some carbon deposit which will increase the contact resistance inducing more heat until melting. Fred


If the conductive layer wears off the contacts of a remote control or other rubberized keyboard is there a way to replace that layer?

depends on whether or not it's really worn off. Could just be glazed over from repeated pressing, since most contact pads are carbon impregnated. Take a cotton swab and buff the rubber contact to remove the shine. Does the trick around 90-95 percent of the time. Also take a swab and buff the contacts on the circuit board, then give it a try. If that doesn't work, contact MCM electronics at 1-800-543-4330 for some contact paint if they still carry it.


How does the area of copper-carbon contacts decide the distribution of current in commutation process of DC machine?

Copper carbon decides the distribution of commutation from the rotation. It tells what direction for it flow.