answersLogoWhite

0

1. Mix one MRE spoonful of calcium hypochlorite in a 6 oz bottle with 1/2 canteen cup of water.

2. Thoroughly mix the slurry and then add it to the water in the trailer.

3. Flush the four taps for several seconds, wait 10min, then flush the taps again. Wait 20min before consumption.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you put a pontoon boat in the water?

To put a pontoon boat in the water, follow these steps: Ensure the boat is properly secured to the trailer. Back the trailer into the water until the boat floats off. Disconnect the boat from the trailer and secure it to a dock or mooring. Remove the trailer from the water.


Was not a step in the three step water treatment process?

Chemical treatment is not typically considered a step in the three primary steps of water treatment, which are generally coagulation/flocculation, sedimentation, and filtration. Chemical treatment is often incorporated into these steps to aid in the clarification and disinfection of water.


Which three major big steps make up the water cycle?

evaporation, condensation, and precipitation.


Do you used a water level to level a 12' by 60' trailer house?

Use a garden hose that is long enough to reach three corners of the trailer house from the fourth corner. Fill the hose with enough water so that the water can be seen from both ends of the hose (a short piece of clear tubing securely connected to either end of the hose would be helpful).Start at the first corner and hold the hose so that the water is level with the the bottom of the frame (or any feature that is at a common level at all parts of the trailer house).Secure the hose in place (or have one person hold it) and take the other end of the hose to the other three corners. Note the height of the water at the other three corners.Adjust each corner of the trailer house until the water is at the same level at all four corners.


How many hypochlorite ampules should be used when rechlorinating a full water trailer?

22 hypochlorite ampules should be used when re-chlorinating a full water trailer.


How do you properly back a boat trailer into the water for launching?

To properly back a boat trailer into the water for launching, start by aligning the trailer with the boat ramp. Use your side mirrors and have someone guide you if needed. Slowly reverse the vehicle, turning the steering wheel in the opposite direction you want the trailer to go. Keep a steady pace and adjust as needed. Once the trailer is submerged, stop the vehicle and secure the boat to the trailer before pulling out of the water.


How many hypochlorite should be used when rechlorinating a full water trailer?

22 hypochlorite ampules should be used when re-chlorinating a full water trailer.


When rechlorinating a full water trailer how many?

22


Where are shut off valves trailer?

Shut-off valves on a trailer are typically located near the water source or connection points, such as at the point where the trailer connects to a water supply line. They can also be found in the plumbing system inside the trailer, often under sinks or near appliances that require water. These valves are essential for controlling the flow of water for maintenance or during emergencies. Always check the owner's manual for specific locations and instructions.


Food helps you survive and water kills you what are you?

trailer trash


When does the trailer for Water for Elephants come out?

November 1st on DVD


What are the steps of a tsunami?

Tsunami do not have steps, they are a water wave.