when the magnitude of voltage of a source is controlled by another small voltage source in the circuit the former is called voltage controlled voltage source and the later is called controller voltage source.
The source of voltage.
Impressed voltage is the external voltage applied to a circuit, whereas induced voltage is generated within a circuit due to a changing magnetic field, typically caused by electromagnetic induction. Impressed voltage is controlled by an external source, while induced voltage is a result of the circuit's own dynamics.
No, the source voltage can not change to a lower voltage without using equipment to do so.
The pushing power of an electrical source is referred to as voltage. Voltage is a measure of the electromotive force that causes electric charges to flow in a circuit. It is measured in volts (V) and determines how strongly the electrical source can push charges through a circuit.
120
The difference between a current control device and voltage controlled device is that for current controlled device, the current is constant and the voltage is variable while for a voltage controlled device, the voltage is constant and the current is variable.
RPS is only the voltage& power controlled device. it can only used for set the input for our wish A device which can change its output according to the voltage supplied to it is called a voltage controlled device.ex. a voltage controlled current source,or a field effect transistor. In a voltage controlled current source the output current changes as the voltage supplied to it changes.
RPS is only the voltage& power controlled device. it can only used for set the input for our wish A device which can change its output according to the voltage supplied to it is called a voltage controlled device.ex. a voltage controlled current source,or a field effect transistor. In a voltage controlled current source the output current changes as the voltage supplied to it changes.
since in an FET the value of the current depends upon the value of the voltage applied at the gate and drain...so it is known as voltage controlled device.. for example..in a mosfet..the current from drain to source depends upon the width of the depletion layer..which in turn depends upon the voltage applied on the gate.. so that is the reason
fet is a voltage controlled device...cut off voltage in fet refers to that voltage of the gate - source junction at which the current flow through channel is zero
fet is a voltage controlled device...cut off voltage in fet refers to that voltage of the gate - source junction at which the current flow through channel is zero
Independent SourcesIndependent sources produce current/voltage at a particular rate that is dependent only on time. These sources may output a constant current/voltage, or they may output current/voltage that varies with time.Dependent SourcesDependent sources are current or voltage sources whose output value is based on time or another value from the circuit. A dependent source may be based on the voltage over a resistor for example, or even the current flowing through a given wire. The following sources are possible:Current-controlled current sourceCurrent-controlled voltage sourceVoltage-controlled current sourceVoltage-controlled voltage sourceDependent sources are useful for modelling transistors or vacuum tubes.
Energy is the source of voltage
A Voltage Controlled Amplifier or VCA is a device whose gain is set by the voltage level of a control signal.
Yes.Source transformation in dependent voltage source can be solved the same like independent voltage source
yes, effectively a voltage controlled conductance. (conductance being the reciprocal of resistance)
The voltage source is the source of the electricity. The conductor is what the electricity flows through to reach its destination. Example: A battery is a voltage source and an electrical wire is the conductor.