A common cloth used to rub down metal is microfiber cloth, which is effective for cleaning and polishing surfaces without scratching. For more abrasive tasks, steel wool or fine-grit sandpaper can be used to remove rust or old finishes. Additionally, specialized polishing cloths made from materials like cotton or flannel are often used to achieve a high shine on metal surfaces.
To remove scratches from a birthstone ring, you can use a jewelry polishing cloth designed for the specific metal of your ring. Gently rub the cloth over the scratches in a back-and-forth motion until they are less visible. If the scratches are deep, consider taking the ring to a professional jeweler for repair.
Place a brown paper bag or cloth over the wax stain on the couch. Iron over the paper bag on a low setting, allowing the heat to melt the wax, which will be absorbed by the paper. Repeat the process with a fresh paper bag until the wax is removed.
You can dissolve baby oil gel by using a natural solvent like rubbing alcohol or acetone. Apply the solvent to the affected area and gently rub it in until the gel breaks down. Once dissolved, you can wipe away the residue with a clean cloth.
Linseed oil will not react with or even penetrate most metal. Wipe the metal down with something soft and absorbent (paper towels are tailor made for applications like this) until all of the oil has been removed. (A film of oil will remain.) Take a clean piece of towel and splash on a little rubbing alcohol and finish up the wipe down. The alcohol acts as a solvent and should remove the remaining film of oil from the metal. If not, once more for full effect. Be careful not to spill the alcohol on stuff, and avoid smearing the oil over adjacent surfaces when wiping and when doing the final mopping up. Dispose of materials used in cleaning with appropriate care and consideration.
Usually gently rubbing the t-shirt with a dry cloth will remove the deodorant. Sometimes you'll have to dampen the cloth and rub a little harder. I've folded thousands of t-shirts that have been tried on by customers and this always works. :)
Rub the surface down with emery cloth and water. This should give you a smooth surface to work on.
Rubbing a ruler with a cloth creates friction, which transfers some of the ruler's electrons to the cloth, giving the cloth a negative charge. This process is called triboelectrification.
Rub with a cloth and baking soda (dry)
When you rub a copper rod with a cloth, electrons are transferred between the two materials due to friction. This can cause a buildup of static electricity on the rod, giving it a slight negative charge.
The cloth will acquire a negative charge. Rubbing the plastic rod transfers electrons from the rod to the cloth, leaving the cloth with an excess of electrons, giving it a negative charge.
Rub my metal balls or rubber balls.
To rub down paintwork, start by cleaning the surface with soap and water. Then use a fine-grit sandpaper (around 320-400 grit) to gently sand the surface in a circular motion to smooth it out. Finally, wipe down the surface with a damp cloth to remove any dust or residue before applying a new coat of paint.
A drop of hand sanitizer, rub with a paper towel or cloth.
Take a damp cloth and wipe it off, don't rub.
I just rub them over with a warm soapy cloth.
Rub a magnet with another metal...
Wear