A fuse will not work successfully if it is connected in parallel with the device it is supposed to protect.First, it will blow because it has no resistance in series with it. Second, once it blows, the device still has power applied to it. Fuses must be wired in series.
U can get 16 SWG
A fuse is an electrical device that is designed to protect an electrical circuit from overcurrent by breaking the connection when a fault occurs. It consists of a thin wire that melts when the current exceeds a certain value, interrupting the flow of electricity.
Using a 5 amp instead of a 3 amp fuse in a circuit may cause the fuse to not blow when it needs to, leading to potential overheating or damage to the circuit components. It could also result in the circuit drawing more current than it is designed for, which may pose a fire hazard. It's important to always use the correct amperage fuse for safety.
It is NEVER a good idea to use a higher value fuse. The reason for the 10 Amp fuse is that it blows at 10 amps which the wire and device being protected is designed to handle. If you substitute 15 amps and that amount of current flows in your device, it may destroy the device and other things in the path of the current.
In the air handler on the circuit board a 5amp fuse.
The Fuse for Licence Plate Lights on a Jaguar XJ8 [1999] is Located in the Fuse Box in the boot/Trunk on the right hand side it is Fuse No.-19 and is a 5AMP one.
i dont no where the relay is . but the fuse for the instrument panel warning lights is behind the glovebox is f2 and is a 5amp fuse
The device will work, but the 3A fuse will blow quicker than the 5A would have.
It can cause a fire. The circuit is protected by the 5 amp fuse. This fuse is protecting the wiring in the circuit from overheating and catching fire. Install a 10 amp fuse and the protection is lost. Very dangerous to substitute a larger fuse.
Check the fuse box. . .the one by the engine, not the interior. There's a fuse that controls those 3 things. Think its a 5amp one.
A fuse will not work successfully if it is connected in parallel with the device it is supposed to protect.First, it will blow because it has no resistance in series with it. Second, once it blows, the device still has power applied to it. Fuses must be wired in series.
No, a fuse will not work successfully if it is connected in parallel with the device it is supposed to protect. Fuses are designed to be connected in series with the device, allowing them to interrupt the current flow when an overcurrent condition occurs. If connected in parallel, the fuse would not experience the same current as the device, and it would not protect it effectively from overcurrent situations.
You might get away with a 5amp fuse, for a time at least, but NEVER use a fuse of higher current than specified, or a non-fusible link like a metal rod.
depends if its a 2 slice or 4 slice toaster and maximum power usage.. I'd say a 5amp for a 2 slice and a 13amp for a 4
The recommended amperage for a fuse to be used with a device that requires a 2.5A fuse is 3A.
The interior fuse box: There are two fuses, The first is the one that says "Radio" 5amp and the second is one labeled "Chime" for some reason both seem to control the power to the radio.