"Ballast heaver" typically refers to a person or device that assists in stabilizing a ship by adjusting the distribution of weight across the vessel. This is done by moving ballast (heavy material) to counterbalance the ship's load and maintain its stability.
To connect a ballast, first, ensure the power is turned off. Then, match the wiring from the ballast to the wiring in the fixture according to the wiring diagram provided with the ballast. Make sure all connections are secure and insulated properly before restoring power.
A T8 LED tube has to be used with a ballast to bring the correct voltage to the tube for it to operate correctly. Removing the ballast from the circuit will prevent the tube from operating.
If a 227V power source is connected to a 120V ballast, the ballast may get damaged due to the excessive voltage. It is important to always ensure that the voltage input matches the rated voltage of the ballast to prevent such issues.
When the ballast is to be purchased, look at the schematic that is on the label of the ballast. There it will tell you which ballast is good for which lamps and also let you know what length of tube the ballast is good for. Most of the new electronic ballasts allow for multiple connections of different size lamps.
No, it is not recommended to use a 70 watt metal halide lamp with a 150 watt ballast. The lamp and ballast wattage should match to ensure proper operation and to prevent damage to the lamp or ballast. It is best to use a compatible lamp and ballast with matching wattages.
Heaver is the correct spelling.
Brent Heaver was born on 1971-06-15.
Probably.
Yes a football is heaver than a soccer ball.
It does not have a ballast resistor.It does not have a ballast resistor.
It does not have an ignition ballast resistor.It does not have an ignition ballast resistor.
no
Oxygen.
A ballast that smells burnt is going bad. The ballast will have to be replaced to fix the problem.
If you mean the ballast in a fluorescent light fitting where the ballast is wired in series with the tube, the answer is "No". Explanation: If no tube is in place, the light fitting's circuit is "open" so there is nothing to take any current from the "hot" supply wire and return it to the "neutral" wire.
A good sentence for the word ballast is.......The ballast is not heavy enough and the boat is about to sink.
A stinger is linemen terminology. Do you mean transformer instead of ballast. Please be more explicit as to what you are doing.