A condenser is a small pipe-like object used to cool evaporated water in Distillation to convert it back to water from a solution.
A2 In electronics:-
A condenser is the old name for a capacitor. It is a device that stores charge.
It consists simply of two metal plates, close to each other but not touching.
Some have a non conducting (dielectric)layer between them, paper, plastic, ceramic etc.
The plates are commonly metal foils, separated by a dielectric and rolled into a tube shape. A wire is attached to each separate plate.
A capacitor will block the flow of DC current, but allow an AC signal through.
It takes a finite time to charge the plates to the full voltage applied. By charging through a suitable resistor, they can be used for timing.
Connected in parallel across a coil, they can be used as a tuned circuit for radio etc.
Large electrolytic capacitors are used across a DC supply to even out dips and interference, by acting as temporary reservoirs.
A condenser is generally an object made from glass, used to condense a gas to a liquid.
A condenser is used in systems to remove heat from a substance, typically by transferring it to another medium such as air or water. In HVAC systems, condensers are used to remove heat from refrigerant vapor and change it back into a liquid state. This process allows the system to operate efficiently and maintain desired temperatures.
Condenser lamp is a laboratory apparatus used to cool hot vapors and liquid. This typically has a large glass tube containing smaller glass tube running the whole length where the hot liquids pass.
Water typically cools to around room temperature (20-25°C) when passing through a Liebig condenser, which is a type of water-cooled condenser used in laboratory settings to cool hot vapors and condense them back into liquid form.
What is the liquid that leaves the condenser called
Liebig condenser, Vigreaux column, Snyder column, West condenser, Allihn condenser, Graham condenser, Dimroth condenser, Friedrichs condenser. There are no shortage of these!
The approach temperature difference (ATD) is used to determine the condenser performance of a water-cooled condenser. It is the temperature difference between the refrigerant condensing temperature and the cooling water inlet temperature. A lower ATD indicates better performance and efficiency of the condenser.
A condenser is generally an object made from glass, used to condense a gas to a liquid.
Well, there's more than one kind of condenser, and your answer might depend upon which you are referring to.
Yes
The pinion knob on a microscope is used to adjust the focus by moving the stage up or down. The condenser level is used to adjust the height of the condenser lens to control the amount of light entering the specimen.
To condense
There are several roles of a condenser system depending on what is using it. In a microscope, a condenser system helps gather and focus light for a clearer view. In an air conditioner a condenser system cools heated gas so it can be used again.
The reason why it is called a barometric condenser is because it makes contact and it is a long vertical pipe into which it condensates and cools the liquid flow to accomplish the removal of pressure. It is also stated that when the pump is used the system is called a low level barometric condenser.
A tube light uses a condenser which is the old term for a capacitor. It functions as a small battery in a circuit.
The condenser knob in a microscope is used to adjust the position of the condenser lens, controlling the amount of light that reaches the specimen. By adjusting the condenser knob, the user can optimize the illumination and contrast of the specimen being viewed under the microscope.
The condenser in a microscope is used to focus and direct light onto the specimen being viewed. It helps provide uniform illumination and optimal contrast for clearer observation of the specimen. Adjusting the condenser can improve image quality and sharpness in microscopy.