answersLogoWhite

0

A fixture WIP (work in progress) refers to a piece of equipment, tool, or accessory that is being worked on or developed for a specific purpose within a manufacturing or production process. It is often used to hold or support a workpiece in a fixed position to enable efficient and consistent processing.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Continue Learning about Natural Sciences

How do you wire a 220 volts light?

The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.


What is a fixture opening?

A fixture opening refers to the space or connection point where a plumbing fixture, such as a sink, toilet, or shower, is installed in a building's plumbing system. It is where the fixture is connected to the water supply and drainage pipes.


How do you release dome from light fixture in ceiling fan?

Disconnect the fixture wires and remove the central mounting nut to release the dome from the light fixture in a ceiling fan.


Can you connect a wall switch and a light fixture to an existing light fixture?

If the question is, can I wire a switch to an existing light fixture (and I must assume that it's something like a pull-chain light fixture), the answer is yes.If the question is, "how do I wire a switch to an existing light fixture that has no external switch", the answer is, "in series".The attached web site gives simple instructions on how to wire a basic light switch to an existing light.See sources and related links below


Fixture unit per fixture equals 1.5 what does this mean?

A "fixture unit" is used to design the pipe sizes in a plumbing system. It does not equate directly to gallons because not all of the fixtures (aka sinks, toilets, tubs etc etc) will be "running" at the same time. Each fixture is assigned a "fixture unit" load by the local authority having jurisdiction (aka the local plumbing code). These are added to together and tables are used to determine the pipe size. EG, a typical bathroom sink is assigned 1.5SWFU (supply water Fixture units) and 1.5DFU (drainage fixture units) BUT a toilet might be 2.2SWFU and 4DFU.