An anchor line hole is typically called a fairlead or a chock. It is a fitting on a boat or ship that guides the anchor line to ensure proper handling and secure anchoring.
An anchor hole is also commonly known as a bolt hole or a fixing hole. It is a hole drilled or created to secure an anchor, bolt, or fastener into a surface for stability or support.
The hole in the prow of a ship is called the hawsehole. It is used for running the anchor chain or cable through for anchoring the ship securely.
The center line of a hole measuring 1 inch in diameter would be located 0.5 inches from the edge of the hole in all directions. This line represents the midpoint of the hole and is essential for accurate positioning and measurements.
The position of an anchor just clear of the sea floor is called the "anchor rode." This term refers to the length of chain or rope that connects the anchor to the boat. When the anchor is properly set, it should be resting on the sea floor while the rode holds the boat in place.
It would be a hole punch.
hawse
An anchor hole is also commonly known as a bolt hole or a fixing hole. It is a hole drilled or created to secure an anchor, bolt, or fastener into a surface for stability or support.
The rope (or "line" as we call it in the nautical world) is called the anchor line. However the the chain, shackle,gear & line that are attached between the actual anchor and the vessel is referred to as the "rode".
A rope attached to an anchor is commonly referred to as a "anchor line" or "anchor rope." It connects the anchor to the boat or vessel, allowing the anchor to hold the vessel in place. The anchor line is typically designed to withstand the forces of wind and current while maintaining the anchor’s position on the seabed.
Anchor rode, safety line or a mooring line.
The hole in the prow of a ship is called the hawsehole. It is used for running the anchor chain or cable through for anchoring the ship securely.
An anchor line is a very heavy rope or chain by which a ship's anchor is hoisted.
It's not a hole, it's a rivet. In the event that the anchor becomes stuck the rivet will shear before breaking the anchor, thus setting the anchor free.
The new New Zealand Anchor advert is by Bobby Darin, called Long Line Rider.
A Hawse Hole Is A Hole In The Bow Of A Ship For The Cable For An Anchor.
An anchor is attached to a boat or vessel by a "Rode" it could consist of rope, chain ,cable, or some kind of line, and can be used in any combination.There is also another term for this and they are called "Hawsers.Also consider mooring linesa rodeJust called an anchor line. However, the last section of the line, attached to the yacht is known as the 'bitter end'
Metal spikes with a hole at the end through which you pass a rope are typically called "anchor pins" or "eye spikes." These spikes are commonly used in outdoor activities like climbing and caving to secure ropes and create anchor points.