0
What else can I help you with?
Is it true that a low density gas must be hot in order to produce an absorption line?
No, a low-density gas does not need to be hot in order to produce an absorption line. Absorption lines are formed when atoms in a gas absorb specific wavelengths of light. The presence of these lines does not depend on the temperature of the gas, but rather on the composition and energy levels of the atoms within the gas.
Who discovered gas discharge tube?
Johann Wilhelm Hittorf, a German physicist, is credited with discovering the gas discharge tube in the mid-19th century. His experiments with cathode rays in partially evacuated tubes laid the foundation for the development of early gas discharge tubes.
How do you get low pressure gas discharge?
Low pressure gas discharge is typically achieved by enclosing gas in a container at low pressure and then applying a high voltage across the electrodes inside the container. This high voltage causes the gas to become ionized, creating a glowing discharge. Examples include fluorescent lights and neon signs.
Discharge line temperature with increase in super heat?
As superheat increases, the discharge line temperature is likely to also increase. This is because superheat represents the temperature rise of the refrigerant vapor above its saturation temperature, which results in higher temperatures in the system. The discharge line temperature tends to follow the trend of superheat in the system.
Why crook tube is called discharge tube?
If it's a *Crookes* tube you're asking about, it's a discharge tube because the applied electrical field causes ionization and a resulting discharge of energy in the form (mostly) of light, depending on the gas or gases in the tube.
Is air condition discharge hot to the touch?
Yes, the discharge line from the compressor can be hot.Yes, the discharge line from the compressor can be hot.
Comparration diameter size of suction and discharge?
The diameter of the discharge line leaving the ac compressor would be smaller than the suction line, because the compressed gas in the discharge line is more dense.
Why is ice not deposited in a freezer?
I assume you mean the ice build up in some freezers? its because some freezers have whats called a hot gass system or defrost installed in them. A hot gas system is... while the freezer is in its off cycle the controller will open up a valve (usually solinoid valve) in the hot gas pipe/line. this line goes from the discharge line to the suction line usually. There are all different hot gas pipe runs, im going the most common so it is less confusing. There for shuting off the valve in the discharge line (the pipe that leaves the compressor) all warm/hot mass will always move toward a cooler/cold mass. since the suction pipe (bigger pipe entering the compressor) is cold the hot refrigerant will move through the hot gas line (defrosting the refrigerated space) to the suction pipe. usually there is some type of component added further down the suction line to save the compressor from and condensed refrigerant entering the compressor.... hope this helped
What is commonly used to defrost the ice from the a low temperature evaporator?
Hot gas from the discharge line of the compressor is routed into the evaporator or electric heating elements are embedded into the evaporator fins. Hot gas is often more efficient because no outside power source is needed to defrost the evaporator coil.
1999 alero no start would fire if primed gas line inside the tank had came off discharge side of pump runs good after reattaching?
the above was the answer the gas line inside the tank had come off even though the crimping clamp was still on it This was the line from pump discharge to the filter
How do you calculate the discharge superheat on a chiller?
To calculate the discharge superheat on a chiller, first measure the temperature of the refrigerant gas at the discharge line using a temperature sensor. Next, determine the saturation temperature of the refrigerant at the corresponding pressure in the discharge line using pressure-temperature charts. Subtract the saturation temperature from the measured discharge temperature to find the discharge superheat. The formula is: Discharge Superheat = Discharge Temperature - Saturation Temperature.
What is liquid receiver in refrigeration system?
It is fitted on discharge line after condenser, where the gas enters in liquid forms.
Why is discharge line leaving outside unit cold on central ac?
The expansion device inside the outside unit expands the refrigerant gas and as a result, the discharge lines chills
On a reciprocating compressor what would be a higher than normal temperature on the discharge gas line?
A higher-than-normal temperature on the discharge gas line of a reciprocating compressor could indicate issues such as low refrigerant charge, restricted flow in the system, or a failing discharge valve. It is important to address these issues promptly to prevent damage to the compressor and ensure efficient operation of the system.
What size gas line will work with a 199900 BTU hot water heater?
depends on the delivery pressure of the gas....
What is an ac discharge and suction lines?
AC discharge and suction lines are components of an air conditioning system. The discharge line carries high-pressure refrigerant gas from the compressor to the condenser, where it releases heat and condenses into a liquid. In contrast, the suction line transports low-pressure refrigerant gas from the evaporator back to the compressor, where it is compressed and cycled again. Proper insulation and maintenance of these lines are crucial for efficient system performance.
When should you insulate hot gas line?
For all systems using HFC refrigerants
