answersLogoWhite

0

Reaming is a machining process used to enlarge and improve the accuracy of a previously drilled or bored hole. A reamer tool, which typically has multiple cutting edges, is used to remove small amounts of material from the hole to achieve precise dimensions and a smooth finish. Reaming is often performed as a finishing operation to achieve tight tolerances and a high-quality surface finish.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Related Questions

What is the suggested spindle speed for reaming?

what is reaming what is reaming


What is difference between reaming and drilling?

Drilling is a cutting process in which drill is used to make a hole. Drilling process usually creates rough surfaces. Therefore, reaming is done after drilling to make a good surface finish, without changing the chemical and physical properties of the material. In reaming, only 5% of the material is removed (rest is removed by drilling process done before).


Can reaming b done on a lathe machine?

reaming can be done on lathe machine - only precaution taken is the reamer is not drawn back till the reaming is complete. Proper coolant is used and the rpms are maintaind slow


What are the ratings and certificates for Romantic Rectal Reaming - 2005 V?

Romantic Rectal Reaming - 2005 V is rated/received certificates of: Australia:Refused Classification (2013)


What is the retaining of heat?

the reataning of heat is all the hat that is reaming


What is the difference reaming operation boring operation?

Boring is generally more accurate than reaming. Also, reamers can only get so large and/or so long before they become unreliable and/or very expensive.


What rhymes with daydream?

screaming creaming reaming seaming Mainstreaming


Why does misha have a difficult time to remaining invisible?

why does misha have a difficult time to reaming inyisible?


What reaming method is there available to remove concrete inside a 2 PVC conduit?

It may be easier to simply cut out the section of conduit and replace it.


What is good pipe leak prevention?

Proper choice of materials and installing the piping with the right hangers and reaming the piping ends Quality in workmanship


What is the value of a Remington rolling block 20 ga shotgun?

The 20 ga shotgun was created by reaming-out the 50 cal. militery musket. I have only seen one.


Why is the helix angle of a reamer negative?

The helix angle of reamer is negative because to make the reamer more regid so that the reamer can withstand the vibration during reaming