The amperage rating for 500 kcmil (thousand circular mils) wire varies based on the type of insulation and installation conditions. For example, in a typical application using THHN insulation, a 500 kcmil copper wire can carry approximately 380-450 amps at 75°C. However, always refer to the National Electrical Code (NEC) and local regulations for precise ampacity ratings based on specific conditions.
No, a 700 amp fuse would not be suitable for a 500 amp circuit. The fuse amperage rating should be equal to or slightly higher than the circuit's maximum amperage to provide proper protection. In this case, a 500 amp fuse or slightly higher would be the appropriate choice.
5.1v is the Voltage, You need to also look at what the Amperage rating is on the charger. 500ma, 1000ma, etc. How many Milliamps?
A motor's service factor is a multiplier applied to a motor's horsepower rating to indicate the level of overload it can handle. The motor's nameplate amperage rating indicates the maximum current it should draw under normal operating conditions. The service factor does not directly impact the amperage rating, but motors with a higher service factor may be capable of handling higher loads and thus draw more current.
The amperage of an electric roaster can vary depending on its size and wattage. To calculate the amperage, you can use the formula: Amperage = Wattage / Voltage. For example, if a roaster has a wattage rating of 1200W and operates on a standard 120V outlet, the amperage would be 10A (1200W / 120V = 10A). It's important to check the specific wattage and voltage requirements of your electric roaster to determine the exact amperage it uses.
The ampere rating of wire would depend on the diameter, length and usage of wire for specific purpose. Without additional input to the question. it will be hard to give an accurate answer.
It is ok to use a fuse with a higher amperage rating and not ok to use a fuse with a smaller amperage rating why?
The amperage rating for a typical ceiling fan is around 0.5 to 2.5 amps.
KCM was born in 1982.
The maximum amperage rating for 10 wire is typically around 30 amperes.
The maximum amperage rating for a 15 amp switch is 15 amps.
The maximum amperage rating for a 40 amp receptacle is 40 amps.
The maximum amperage rating for a typical dryer outlet is 30 amps.
The maximum amperage rating for an 18AWG wire is typically around 16 amps.
The maximum amperage rating for the ceiling fan in this room is 2.5 amps.
The maximum amperage rating of the 20 amp switch is 20 amps.
No, a 700 amp fuse would not be suitable for a 500 amp circuit. The fuse amperage rating should be equal to or slightly higher than the circuit's maximum amperage to provide proper protection. In this case, a 500 amp fuse or slightly higher would be the appropriate choice.
The maximum amperage rating for a standard electrical outlet is typically 15 or 20 amps.