answersLogoWhite

0

The color of a 13-volt cable can vary depending on the manufacturer and the specific application. However, in many cases, standard color coding practices apply, where red typically indicates positive and black indicates negative or ground. It's essential to refer to specific wiring diagrams or standards relevant to your region or device to ensure proper identification. Always verify with the manufacturer’s specifications for accurate information.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Continue Learning about Natural Sciences

Can you use armored cable to wire 277 volt lights?

Yes, armored cable can be used to wire 277 volt lights. However, be sure to select the appropriate type and size of armored cable rated for the voltage and current requirements of the lighting system to ensure safety and compliance with electrical codes and regulations.


How do you reduce volt drops in cables?

You can draw less current, half the current gives half the amount of volt drop. Or use a thicker cable because doubling the cross-section area would also give half the volt drop.


What size cable for a cooker oven only max 2600watts?

For a cooker oven with a maximum of 2600 watts, a 2.5mm cable is recommended to handle the load safely. This size of cable is commonly used for appliances with this power rating and will ensure that the electrical supply is properly distributed without overheating the cable. Be sure to consult a qualified electrician for installation to ensure safety and compliance with wiring regulations.


How many amps does a 240 volt oven draw?

In North American homes, new homes are prewired to use a 40 amp circuit. A 40 amp two pole breaker in the distribution panel protects a #8 three wire cable. This cable connects the 240 volt supply to the range and oven.


How many AMPS will a 10 AMP 12 volt charger charge a 36 volt three battery in series system with?

A 10 amp charge will only output 10 amps and 12 volts. So, if you want to charge thee 12 volt batteries hooked in series you will have to disconnect the positive cable from each battery and charge then individually. You cannot charge three 12 volt batteries hooked in series. That requires a 36 volt charger.

Related Questions