They are called I squared R losses. That is the formula for calculating power (P) in watts. P=I^2*R. I equals current in amps. R equals resistance in ohms. Also if the voltage (E) is known the formula is P=E^2/R. The current of electrons meets the resistance of the coil wire. That results in heat in inductor and transformer coils.
Produced, in great abundance!
True. Heat produced by nuclear fusion in the core of stars causes them to shine brightly and emit light and heat into space.
exothermic
If heat is produced by a chemical system, it means that an exothermic reaction is taking place. In an exothermic reaction, heat is released to the surroundings as a byproduct of the reaction. This can result in an increase in temperature of the system.
heat, light
heat energy
depending on the stray capacitance it can be from a few ten volts to a few kilo volts.
Yes, it possible to heat a coil using dc power supply. An inductor resists a change in current, proportional to voltage and inversely proportional to inductance. The equation of an inductor is di/dt = v/L An ideal inductor, if connected to an ideal DC supply, with ideal conductors, would ramp up current in a linear fashion without limit, eventually reaching infinity amperes after infinite time. Since no inductor is ideal, nor is any DC supply, nor is any conductor, the current would reach a maximum based on the capacity of the DC supply and the DC resistance of the inductor and conductors. Since the DC resistance of the inductor is also not zero, this means, by Ohm's law, that the inductor must dissipate some power. That will cause the inductor to heat up.
The resistance of an inductor can affect the efficiency of an electrical circuit. Higher inductor resistance can lead to energy loss in the form of heat, reducing the overall efficiency of the circuit. Lower resistance inductors are more efficient as they waste less energy.
what is an inductor used for
Since we know that inductance of an inductor depends on the length of inductor by the formula L=muAN*N/l, where l is the length of inductor. So by varying the length of inductor we say that inductance of inductor varies.
Opposition to the flow of AC current produced by an inductor. Measured in Ohms and varies in direct proportion to frequency.
"Charge?" The field produced by an inductor exists ONLY while the current flow is changing,
How do you propose to connect a decreasing current to the inductor ? The initial current through the inductor is zero, and you want to connect it to a current which is not zero and decreasing. At the instant you make the connection, the inductor current is zero, and it must rise to the non-zero value where you want it to begin decreasing. The current in the inductor cannot change from zero to something in zero time. As it rises from zero to the initial value, guess what . . . the inductor is storing energy in its magnetic field, while producing the usual voltage equal to [ L di/dt ].
The percentage of radiation produced compared to the amount of heat produced depends on the source of heat. For example, in a typical fire, about 70-90% of the heat produced is in the form of radiation. In contrast, for electric heating sources, the percentage of radiation produced is lower as most of the heat is convective.
Solar heat is produced by stars. The people who live on Earth get their solar heat from the sun.
heat