answersLogoWhite

0

There are approximately 80 acronyms for RIP: some of them are measurements, others are not. It is necessary to have more information in order to answer the question.

User Avatar

Wiki User

8y ago

What else can I help you with?

Related Questions

What metric does rip v1 use to update routing tables?

RIP version 1 uses hop count as a metric to update routing tables. It measures the number of routers a packet must travel through to reach a destination network. Lower hop counts are preferred, as they indicate a shorter route.


What metric does the RIP routing protocol consider to be infinity?

16


What statement correctly describes a feature of RIP?

RIP (Routing Information Protocol) is a distance-vector routing protocol that uses hop count as its metric for path selection. RIP routers broadcast their entire routing table every 30 seconds as a broadcast. RIP is classified as a classful routing protocol, meaning it does not support the use of VLSM (Variable Length Subnet Masking) and requires all devices in a network to use the same subnet mask.


What allows RIP to avoid routing loops by advertising a metric of infinity?

Split horizon with poison reverse.


Why is the show ip route command important for troubleshooting commands?

Compared to RIP, EIGRP has a lower administrative distance. Compared to EIGRP, RIP has a higher metric value for the route. Compared to RIP, the EIGRP route has fewer hops. Compared to RIP, EIGRP has a faster update timer.


When rip is used in routing protocol which metric is used to route information across the network from location to location?

A hop. :)


What measurement system does South Africa use?

How is the metric system use in America? How is the metric system use in Australia? How is the metric system use in Japan? How is the metric system use in Thailand? How is the metric system use in sweden? How is the metric system use in anywhere? Know the answer now?


What metric would you use for a shoe?

what metric would you use for shoes


What routing protocol has a limitation of 15 hops?

RIP RIPnetworks are limited in size to a maximum of 15 hops between any two networks. A network hop with a hop count of 16 indicates an unreachable network. The other routing protocols do not use the hop count as the metric, EIGRP uses bandwidth and delay for the metric. OSPF and IS-IS use a relative link cost, BGP uses paths, rules, and policies for the metric.


What is the purpose to use RIP in routing?

the purpose of rip is used in routing........


When collecting data and doing experiment what system of measurement do most scientists use?

Metric system


What are features of RIP?

RIP Characteristics " RIP has the following key characteristics: RIP is a distance vector routing protocol. RIP uses hop count as its only metric for path selection. Advertised routes with hop counts greater than 15 are unreachable. Messages are broadcast every 30 seconds. The data portion of a RIP message is encapsulated into a UDP segment, with both source and destination port numbers set to 520. The IP header and data link headers add broadcast destination addresses before the message is sent out to all RIP configured interfaces.