0
At 12 ATM pressure and -40°C, carbon dioxide exists in a solid state, commonly known as dry ice. At this temperature and pressure, carbon dioxide does not enter a liquid phase; instead, it sublimates directly from solid to gas when it warms up. The critical point for carbon dioxide is around 31°C and 73 ATM, meaning that under the specified conditions, it cannot be in liquid form.
What else can I help you with?
Ask us anythingUsing the phase diagram for CO2 what phase is carbon dioxide in at -60C and 1 ATM pressure?
At -60°C and 1 ATM pressure, carbon dioxide is in the solid phase, commonly known as dry ice. This is because the phase diagram for CO2 shows that below its triple point (approximately -56.6°C at about 5.1 ATM), carbon dioxide cannot exist as a liquid at 1 ATM pressure. Therefore, at -60°C and 1 ATM, CO2 is solid.
What phase is carbon dioxide in at -60 and ATM pressure?
At -60 degrees Celsius and standard atmospheric pressure (1 ATM), carbon dioxide exists in a solid phase, commonly referred to as dry ice. This temperature is below the sublimation point of carbon dioxide, where it transitions directly from solid to gas without becoming a liquid. Therefore, at these conditions, carbon dioxide would not be found in its gaseous or liquid form.
What phase is carbon dioxide in at 12 ATM pressure and -40C?
Both values are above Triple point at 518 kPa and −56.6 °C, so it is liquid
What happen to carbon dioxide at 10 ATM pressure as the temperature is increased from -70c-0c?
At a pressure of 10 ATM, carbon dioxide (CO2) undergoes phase changes as the temperature increases from -70°C to 0°C. Initially, at -70°C, CO2 exists as a solid (dry ice). As the temperature rises, it sublimates directly into gas without passing through a liquid phase, as the pressure is above its triple point. By 0°C, CO2 remains in the gaseous state under these elevated pressure conditions, as it does not reach the liquid phase before fully transitioning to gas.
What phase is present at 186 Ccirc rmC and 1.0 ATM?
At 186 °C and 1.0 ATM, the substance is likely in the gas phase, assuming it is a common substance like water or a hydrocarbon. For water, this temperature exceeds its boiling point at standard atmospheric pressure (100 °C), indicating that it would exist as steam. If the substance in question is different, the phase could vary depending on its specific properties and phase diagram.
What phase is carbon dioxide in at 5 ATM pressure and -20?
In these conditions carbon dioxide is a gas.
Ask us anythingUsing the phase diagram for CO2 what phase is carbon dioxide in at -60C and 1 ATM pressure?
At -60°C and 1 ATM pressure, carbon dioxide is in the solid phase, commonly known as dry ice. This is because the phase diagram for CO2 shows that below its triple point (approximately -56.6°C at about 5.1 ATM), carbon dioxide cannot exist as a liquid at 1 ATM pressure. Therefore, at -60°C and 1 ATM, CO2 is solid.
Using the phase diagram for CO2 what phase is carbon dioxide in at -20C and 1 ATM pressure?
The triple point of Carbon Dioxide is 216.55 K (−56.60 °C) and 517 kPa (5.10 atm). Since that puts the pressure (1 atm) below the triple point pressure (5.1 atm) we are only concerned with the where the solid/vapor equilibrium line falls relative to the temperature. At 1 atm, the sublimation temperature of Carbon Dioxide is -78.5 °C - considerably below -20 °C so that puts the Carbon Dioxide firmly in the vapor region of the phase diagram.
Using the phase diagram for CO2, what phase is carbon dioxide in at 12 atm pressure and -40 C apex?
At 12 atm pressure and -40°C, carbon dioxide is in the solid phase according to the phase diagram. This corresponds to the region of the phase diagram where CO2 exists in the solid state at those specific pressure and temperature conditions.
What phase is carbon dioxide in a negative 60 degrees Celsius and 15 ATM pressure?
The triple point of Carbon Dioxide is 216.58 K (-56.57 °C), 518.5 kPa (5.117197 atm) so pushing the pressure higher and the temperature lower shifts it solidly into the solid phase. Another way of checking it is to note that the vapor pressure of solid Carbon Dioxide at -60 °C is 4.043 atm so increasing the pressure to 15 atm would certainly push it further into the solid phase.
What phase is carbon dioxide in at -60 degree C and 1 ATM pressure?
At -60 degrees Celsius and 1 ATM pressure, carbon dioxide would be in a solid phase. This is because the temperature is below its sublimation point, causing it to directly change from a gas to a solid without passing through the liquid phase.
What phase is carbon dioxide in at - 20 degrees Celsius and 1 ATM pressure?
At -20 degrees Celsius and 1 ATM pressure, carbon dioxide is in the solid phase (dry ice), as it undergoes direct sublimation from a gas to a solid at temperatures below its sublimation point.
What phase is carbon dioxide in at 20 degrees Celsius and 25 ATM pressure?
At 20 degrees Celsius and 25 ATM pressure, carbon dioxide would be in a supercritical state, exhibiting properties of both a gas and a liquid.
What phase is carbon dioxide in at 20C and 25 ATM pressure Using the phase diagram for CO2?
solid, I just took the text on apex
Consider the phase diagram below What phase change occurs as the pressure on the sample at -50ºC is increased from 1 atm to 3 atm?
At -50°C and 1 atm, the substance is in the solid phase. With an increase in pressure to 3 atm, the phase transition will occur from the solid phase to the liquid phase.
What phase is carbon dioxide in at -60 and ATM pressure?
At -60 degrees Celsius and standard atmospheric pressure (1 ATM), carbon dioxide exists in a solid phase, commonly referred to as dry ice. This temperature is below the sublimation point of carbon dioxide, where it transitions directly from solid to gas without becoming a liquid. Therefore, at these conditions, carbon dioxide would not be found in its gaseous or liquid form.
Using the phase diagram for CO2 what phase is carbon dioxide in at -60C and 15 ATM pressure?
(Explanation): If you look at the phase diagram for CO2, and you draw a lines where the temperature and pressure meet, you will see that the point will be inside the zone that is 'solid', so it is in the solid state.
