running wire 12-2 300ft w/9ea. 27watt lights what size breaker should be used
The size of the circuit breaker for a pool pump should be determined by the pump's current draw. The breaker should be sized to accommodate the pump's full load amperage with a 125% safety margin. Most pool pumps typically require a 15 or 20 amp circuit breaker.
6ga should be used. It might not be against codes where you are,and you might have a 50amp installed for something that only uses 40amp, but it should be done right, and 6ga should be used off of a 50amp breaker.
For a circuit with a load of 10 amps, a breaker of 15 amps should be used for adequate protection. It is important to choose a breaker size that is slightly higher than the load to prevent frequent tripping and ensure safety.
Depends on the wire size used in the circuit. If you use AWG # 14 wire you must use a 15 amp breaker. If it is wired with AWG # 12 wire then you use a 20 amp breaker. If a AWG # 10 wire is used then a 30 amp breaker is required. The breaker protects the wiring from overheating so you must use the proper size breaker for the wire used.
The biggest circuit breaker in any home is the main breaker located in your main breaker panel that is installed where your electrical service cable comes into your home.
A 6-gauge wire should be used with a 60 amp breaker.
For a 25 amp breaker, a wire size of at least 10 gauge should be used to safely handle the current.
A 40-50 amp breaker is typically used for an electric range.
For a 30 amp breaker, a wire size of at least 10 gauge should be used to ensure safe and proper electrical connections.
50 amp breaker wired with AWG # 6 wire.
For a 100 amp breaker, a wire size of 2 AWG (American Wire Gauge) should be used to ensure proper electrical safety and performance.
For a 50 amp breaker, a wire size of at least 6 AWG (American Wire Gauge) should be used to safely handle the electrical load.
For a 50 amp breaker, a wire size of at least 6 AWG (American Wire Gauge) should be used to safely handle the electrical load.
The size breaker you use is determined by the size wire used in the circuit. If you use AWG #12/2 wire then use a 20 amp breaker. If you use AWG # 14/2 then use a 15 amp breaker.
30 amp breaker with #10 gauge copper wire
For a standard refrigerator, a 15-20 amp circuit breaker is typically recommended.
For a 40 amp breaker, a wire size of at least 8 AWG (American Wire Gauge) should be used to ensure safe and proper electrical conductivity.