Not enough information. Lights? Pumps?
The frequency has no direct relationship to the size of wire. Wire is sized as to the amount of current a load draws in a circuit.
The breaker size for a TNIA-10 wire depends on the maximum current carrying capacity of the wire, which is typically indicated on the wire's packaging or in its specifications sheet. You should select a breaker that is rated slightly higher than the wire's maximum current capacity to ensure safety and avoid overloading the wire. It is recommended to consult with a qualified electrician for specific guidance on breaker sizing for your installation.
Most lamp wire is parallel #16 conductors.
The wire size is dependent upon the wattage size of your water heater. The higher the wattage the larger the wire size. A standard 3000 watt heater will use a two pole 20 amp breaker connected to 2C #12 wire.
Wire size refers to the physical dimensions of a wire, usually expressed in millimeters or inches. Gauge size, on the other hand, is a measurement of the wire's diameter based on a specific gauge system (such as AWG or SWG). So, while wire size refers to the actual physical dimensions, gauge size is a standardized measurement used for electrical wiring.
For accommodating 4/3 wire, a 1-inch conduit size should be used.
For a 100 amp service in copper, a wire size of 3/0 AWG should be used.
For a 15 amp circuit, a 14-gauge wire should be used.
A 6-gauge wire should be used with a 60 amp breaker.
For a 25 amp breaker, a wire size of at least 10 gauge should be used to safely handle the current.
For a 30 amp 240 volt circuit, a wire size of 10 AWG should be used.
For a 100 amp breaker, a wire size of 2 AWG (American Wire Gauge) should be used to ensure proper electrical safety and performance.
For a 50 amp breaker, a wire size of at least 6 AWG (American Wire Gauge) should be used to safely handle the electrical load.
For a 50 amp breaker, a wire size of at least 6 AWG (American Wire Gauge) should be used to safely handle the electrical load.
For a 30 amp circuit, a wire size of 10 AWG (American Wire Gauge) should be used to ensure safety and proper electrical conductivity.
The frequency has no direct relationship to the size of wire. Wire is sized as to the amount of current a load draws in a circuit.
For 10/2 wire, a 3/4 inch conduit should be used.