0
What else can I help you with?
Can you connect 240 3 ph motor to 480 3 ph by dropping a leg?
No, you cannot connect a 240V 3-phase motor to a 480V supply by dropping a leg. The motor is designed to operate at a specific voltage, and changing the voltage in that manner can damage the motor and pose a safety hazard. It is recommended to use a transformer to step down the voltage to match the motor's rating.
What is the solution for running three phase induction motor at voltage less than its rated voltage to drive full load?
The solution to this problem is to get the same size motor in HP at the correct voltage. This way the motor can correctly drive the connected full load without tripping the motor protection.
How can you know the motor's volt if it has to move a robot with known weight?
To determine the motor's voltage needed to move a robot with a known weight, you would calculate the torque required to move the robot and select a motor that can provide that torque at a specific voltage. Factors such as friction, wheel size, and terrain should also be considered in calculating the motor's voltage for efficient robot movement.
18kW motor will take how many amps?
To calculate the amps drawn by an 18kW motor, you can use the formula: Amps = Power (Watts) / Voltage (Volts). Assuming a standard voltage of 120V, the motor would draw approximately 150Amps. Note that actual amps will depend on the specific voltage of the motor.
How do you drop the voltage of a 12v dc motor to slow it down?
You can use a DC motor speed controller with pulse width modulation (PWM) to regulate the voltage supplied to the motor, thus slowing it down. By adjusting the duty cycle of the PWM signal, you can effectively control the speed of the motor while maintaining a constant voltage input. Another option is to use a resistor in series with the motor to reduce the voltage, but this method is less efficient and may cause power loss and heating issues.
What years were noma ornamotion motors used?
1998
What is the voltage tolerance of a standard electric motor?
the voltage tolerance of a standard electric motor is
How do i switch a 3 phase motor from low to high voltage?
You can't. You must supply the motor with it's required voltage. If it's a dual voltage motor, follow the wiring schematic on the motor nameplate to switch from low to high voltage.
When was Noma Bar born?
Noma Bar was born in 1973.
When was Noma Gurich born?
Noma Gurich was born in 1952.
When was Hiroshi Noma born?
Hiroshi Noma was born in 1915.
When did Hiroshi Noma die?
Hiroshi Noma died in 1991.
When was Noma Dumezweni born?
Noma Dumezweni was born in 1969, in Swaziland.
What will happen to a motor if it is supplied with lower voltage than its rated voltage?
The amperage to the motor will go higher.
Can a voltmeter be used to measure voltage in and out of a starter motor?
Voltage flow into a starter motor, never out of it. Use the voltmeter to measure the voltage at the starter motor before starting to crank and then whilst it is cranking. (Before cranking, the voltage appears across the starter motor relay only.)
Where can one purchase Noma lights?
Though Noma lights are available directly from the Noma Direct site, one may also purchase Noma lights from many other places. Amazon sells some Noma lights. Service Lighting is another place that sells Noma lights for a good price. Also, Do It Best Hardware has Noma lights available. And eBay is a fantastic place to shop for Noma lights, from recently made sets to sets dating from the 1940's.
What voltage is found on a single phase motor?
Ac voltage
