A bad circuit breaker. Replace it.
If your smoke detector is bleeping you have a serious risk of fire and the circuit breaker must not be reset until the fault that caused it to trip is investigated.
Short circuit blowing fuse or breaker.
A short circuit is the term for hot touching ground. This can cause a breaker to trip which will then open the circuit.
The electromagnet in the circuit breaker is used for instantaneous tripping if short-circuit condition arises. At defined current level the electromagnet develops the force high enough to cause the tripping of the mechanism.
No, a circuit breaker is a safety device that is used in a circuit to limit the amount of current in an overload or short circuit condition. The number on a breaker is the top end current that the breaker will handle before opening the circuit.
No. A circuit breaker is like a fuse, it protects a circuit from a catastrophe if a dead short should occur.
There are two conditions that would cause a breaker to trip off. One is an overload of the circuit and the other is a short circuit on the circuit. The heating element within the breaker is what monitors for circuit overloads.
Overloaded circuit, short in circuit, or defective switch.
Look for the cause of the trip and correct. Reset the circuit breaker. If it continues to trip it might be an overloaded circuit, loose connections in the circuit, or a short in the wiring somewhere.
If your smoke detector is bleeping you have a serious risk of fire and the circuit breaker must not be reset until the fault that caused it to trip is investigated.
Short circuit blowing fuse or breaker.
the maximum short current that can be safely break by the circuit breaker.
A short circuit is the term for hot touching ground. This can cause a breaker to trip which will then open the circuit.
The electromagnet in the circuit breaker is used for instantaneous tripping if short-circuit condition arises. At defined current level the electromagnet develops the force high enough to cause the tripping of the mechanism.
A circuit breaker must be reset to ON after a short circuit but does not need to be replaced. It depends on the type of CB. A fuse is also a circuit breaker and it needs to be replaced after a short circuit. Relayed circuit breakers have to be "picked up" after a dropout and need not be replaced as such.
No, a circuit breaker is a safety device that is used in a circuit to limit the amount of current in an overload or short circuit condition. The number on a breaker is the top end current that the breaker will handle before opening the circuit.
A breaker trips when its rated current has either been slightly exceeded over a period of time or grossly exceeded instantaneously.