It means you have effectively no resistance to current flow. Whether this is good or not depends on whether you WANT resistance to current flow.
If you're testing a length of wire, a cable, or something like that, having your ohmmeter read zero would be good.
If you're testing a motor or something else that needs to have resistance to work, having your ohmmeter read zero is bad and is called a Short Circuit.
Never connect the ohmmeter's leads across a voltage.On an analog meter, adjust the zero before use.Turn your ohmmeter off when not in use, to protect against voltage drain.When your ohmmeter's battery is low, or your meter won't be used for a while, remove the battery to prevent damage to the meter from battery leakage.
Go
The easiest way is to use an Ohmmeter. This function is usually built into most multimeter that can be bought at any hardware store. An Ohmmeter measures the electrical resistance of a material. The lower the number the more conductive that material is. If the Ohm reading is above the maximum reading on the meter then their is infinite resistance which means that the material is not a conductor of electricity.
Zero! that's why it is called zero gravity!
You would say 0.80 as "zero point eight zero" or "eighty hundredths."
When the lead probes of an ohmmeter are touched together, the ohmmeter should read close to zero ohms, indicating a short circuit or very low resistance between the probes.
The reading will be very close to zero ohms.
This is false. A zero reading is what you get when you press the probes of themeter together with nothing between them, to make sure the meter is working.That's about as closed as the circuit under test can get.
On an analog ohmmeter, measurements are more precise and more accurate at the zero end of the scale.
resistance to current flowAn ohmmeter meassures resistance
Never connect the ohmmeter's leads across a voltage.On an analog meter, adjust the zero before use.Turn your ohmmeter off when not in use, to protect against voltage drain.When your ohmmeter's battery is low, or your meter won't be used for a while, remove the battery to prevent damage to the meter from battery leakage.
No. An Ohmmeter measures electrical resistance to the flow of current.
An ohmmeter is connected in parallel to a resistor. Be sure that there is no power in the circuit when testing.
Turn off the supply before using the ohmmeter,it will damaged your ohmmeter when supply is present.
An ohmmeter is a type of electrical metre that measures electrical resistance. When in resistance-measuring mode, multimeters also operate as ohmmeters. An ohmmeter measures the resistance of a circuit or component by passing electricity through it.
Remove and test with an ohmmeter Explain how to test with an ohmmeter?
What is the function of rheostat