answersLogoWhite

0

What else can I help you with?

Related Questions

What is a historical event happened in Texas?

Spindle top Blows


How are pulleys used to change the chuck speed of a pillar drilling machine?

The pulley attached to the motor usually has a large wheel on bottom, two medium wheels in centre of the stack and a small one on top. The front, or spindle pulley, is fitted with the large wheel on top. The drive belt can go from top at back, to top at front -thus driving the spindle slowly. If you changed the belt to the big motor pulley and a small spindle pulley the spindle would rotate faster.


What year did Lucas struck oil at spindle top?

January 10, 1901


Who struck oil on Spindle Top Hill in Texas?

Al, Jim, and Curt Hamel


Why was the spindle top important to Texas history?

Its he most oil found at once, and it changed the economy


What caused oil boom in Texas?

The spindle Top explosion started the oil boom in Texas.


What caused the oil boom in Texas?

The spindle Top explosion started the oil boom in Texas.


Who discovered Michigan?

Carrot top


What is a presta valve?

The pipe - the valve stem - is narrower at the top. And the valve spindle sits with a thicker part below the narrower part of the stem. When you turn the little nut on top of the spindle you pull the thicker part of the spindle into the narrower part of the stem to create a seal and to close the valve. To open you unscrew the nut and push the spindle down.


What structure forms in prophase along which the chromosomes called?

The answer is Spindle Fibers.


A fan like microtubule structure that helps separate the chromosomes is a?

the spindle


What is the best spindle for a goped sport?

It's hard to beat the stock spindle size. You can go bigger but that will gear your spindle drive Go-Ped model to go faster. that sounds good but it take power to go faster so it will take a little longer to get to speed and your ability to climb hills gets restricted. Gear it to go too fast by putting a too big of spindle and the engine will not have enough power to get to top speed and you have a scooter that only bogs around with a gutless feal to it. You can also put a smaller sized spindle on it and gear it lower. Doing this will make it a powerful hill climber but it will not go as fast as stock at top speed.