answersLogoWhite

0

There are many places where one could buy a timer to control a light switch. One looking for a timer to control a light switch should visit popular on the web sources such as Lowe's, Intermatic, and Honeywell Store.

User Avatar

Wiki User

12y ago

What else can I help you with?

Continue Learning about Natural Sciences

Where can you buy a switch plate?

Switch plates are used to cover electric boxes on light switches. They can be found at any home improvement store such as Home Depot or online at retailers such as Amazon.


Why does an energy saving light bulb with a light sensor stay on in daylight?

The sensing unit on the fixture is thinking that it is night time. If your fixture has a switch before the light, that has to be left on for the sensor to work, try the following. Turn the fixture off with the switch and leave it off for about ten minutes. Turn the switch back on and the fixture will turn on. If the sensor circuitry is working the fixture will turn off after your "delay on" setting is reached. If there is no switch before the fixture check to see if the sensor has been covered, fooling the sensor into thinking it is night time. If it is a hollow tube type sensor, sometimes hornets will lay an egg in there and cover the sensor with a mud patch. As a last resort change the sensitivity control so that is senses daylight sooner, allowing the sensor to shut off earlier. If none of the above work its time to buy a new sensor. These can be bought individually and installed into the old fixture.


Where can you buy a heat and light bulb from?

Usually from your local hardware store.


Is it legal to use a gas generator to power a home - what are the codes and standards?

No buy a transfer switch and wire it direct to your panel.


How do you connect 2 black and 2 red wires to a new switch?

switches work by interupting the hot side of a wire loop, so what you do is you wire your non hot (usually black) wires directly to the device you are trying to control, next, to one side of the switch you connect your two reds, then to the other side of the switch connet the hot lead from your device.