answersLogoWhite

0

remember the + side of the speaker basically means neutral, in all electric projects the - is always the live line, so if + means neutral that basically means that ground would also be neutral, speakers dont need ground, so if u wish connect + with neutral on the speaker.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Natural Sciences

Is ground wire the same as the negative wire in speaker wire?

No, the ground wire and the negative wire in speaker wire are not the same. The negative wire carries the audio signal, while the ground wire provides a path for electrical safety and interference reduction. Both wires are essential for proper speaker operation.


Does the ground wire from a 240 volt tankless water heater connect to the common wire?

Any ground wire has to be connected to an independent ground wire that returns directly to the distribution panel and not to the neutral of the circuit.


How do you wire a three wire 220v for dryer White to white but where does black and ground go?

If the cable you are trying to connect the dryer up to only has a white, black and ground wire, then the dryer is not going to work. The cable needs to be a three wire, the ground wire is never counted when discussing house wiring. Open up the electrical access panel on the back of the dryer. You will see a terminal block. A red and black and white connect to this terminal strip. The "hot" wires are connected to the outside terminals. The neutral (white) wire will be in the center. Connect the ground wire to the frame of the dryer. It is very important that this ground wire be connected as this is the wire that carries the fault current to trip the breaker should a fault arise.


Can you connect a 3 wire 120 Volt with ground to a 2 wire House wire has black and white and ground Appliance has black red white and ground?

To answer this question fully the type of appliance has to be stated and its voltage.


I see only a red and a green wire coming out from ceiling box. What are they and how do you connect them to a ceiling light?

Normally red or black is the hot wire and green is the ground. However someone may have used the green wire as the neutral wire which is normally white. Just connect the black wire from the light to the red wire and the white wire from the light to the green wire and see if it works. If not you have to pull the wires out of the ceiling box and see how they wired it.

Related Questions

Is ground wire the same as the negative wire in speaker wire?

No, the ground wire and the negative wire in speaker wire are not the same. The negative wire carries the audio signal, while the ground wire provides a path for electrical safety and interference reduction. Both wires are essential for proper speaker operation.


How do I rewire an ungrounded plug?

If there is no ground wire connect the ground wire to the neutral wire.


What color is the ground speaker wire in a mitsubushi galant 1999?

The chasis is the ground. There is no wire.


Speaker wire with white stripe on one wire is that the ground wire?

Most will say that the white striped wire is the ground. The bottom line is that it doesn't really make a difference as long as your amp ground goes to your speaker ground. This is very important!


How do you wire a wire to a wire?

If you are connecting 120 volts, you connect the black wire to the breaker, white wire to the neutral bar, and ground wire to the ground bar. If you are connecting 240 volts connect the black & white wires to the breaker, & ground wire to the ground bar.


Does all romex have a ground wire?

Some older wire does not have a ground. All you can do in that case is use a jumper wire to connect the ground to the neutral.


Can you connect a laptop to a speaker system through a usb wire?

no, it is not possible.


What colours are the live wires for pug 306 as you are trying to wire in a CD player?

the cheap and easiest way to do this is find a good earth, and connect the negative off an old (working) speaker to it via a wire. then with the ignition off,connect another wire to the positive of the speaker, and test each wire with the positive wire, when the speaker "pops" that is the permanent live, then turn the key to ignition 1 and do the same again(switch, aka ignition live), then turn the lights on and do it. After this you will need to then connect the permanent live and test with the negative wire for the permanent ground p.s. after you have found each wire make sure to secure the wire with electricians tape, or fully connect each one in turn, to avoid fusing your car electrics with lives touching


How do you wire a sub in a Saturn sc?

Connect the sub woofer to the equalizer or amplifier. The positive wire will need to be connected to a power source. Connect the ground wire. Connect the auxiliary wire to the amplifier.


Where do you hook the ground wire on a porcelain light fixture on a metal box?

Connect the ground wire to the metal box.


How do you bypass the e break for the dual dvd710?

Easy, Ground it with your stereo ground wire.... (make the pink wire and black wire connect to the Main Ground wire which is also Black)


How do you install a bass blocker?

You tap into the positive speaker wire and attach the bass blocker to that. So there will be wire then bass blocker, then more wire, and speaker. It takes about 5 minutes if you know how to cut/strip/connect wire.