answersLogoWhite

0

The door ajar switch on a 1993 Mercury Topaz is located in the door latch. The switch is triggered by the top hook of the latch. If the problem is having to frequently slam the door a second time to make the seat belt work, try to adjust the striker bolt attached to the door frame up a bit. Works for me.

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Natural Sciences

Why does courtesy light flash and dinging noise occur in 1996 Dodge Stratus when driving?

Usually that means the doors are open. If they are closed, its probably the door switch. Easy and inexpensive part to fix. Its the little black switch located on the B- and C-pillars near the latch. Two screws and a electrical quick disconnect and its out. Install is reverse.


Internal lights wont switch off?

Try checking the switches on the door frames. The switches are spring loaded; when you close the door it breaks the contact. Start with the driver's door. The driver's door receives the most use. Also: the switch can break and fall into the door pillar.


You are in a room that has 3 switches and a closed door The switches control 3 light bulbs on the other side of the door Once you open the door you may never touch the switches again?

Turn on one light and leave it on for a little while then turn it off. Turn the next light on and open the door. Go up and feel the light bulbs..the warm one is the first loth switch,, the one that is still on is obviously the second light switch and the cold/regular temperature light bulb is the last switch that you didn't touch.


Why does 1996 ranger door alarm and cab lights stay on only with warm air temps when its cold its normal. Is there a way to locate and remove the Dinger?

Sounds like there is a problem with the door ajar switches. There is one on each door. It looks like a push button. It is usually located on the hinge side of the door. Try spray some silicone spray and working it in and out.If that doesnt work then one will have to be replced. Try one door then the other to find the bad one. switch is inside door and is part of latch can be unplugged i did mine


When am switch does not contain electricity it represents a?

When a switch does not contain electricity, it represents an open circuit, meaning that the electrical current is not able to flow through the switch. This can be compared to opening a door, where the pathway is blocked and current cannot pass through.

Related Questions