The best position for a reading lamp in the dark is typically at a height that allows the light to shine directly onto the pages of your book without creating glare. Place the lamp to the side of your reading position, usually on the opposite side of your dominant hand, to minimize shadows. Additionally, ensure the light source is adjustable, so you can direct the illumination as needed for comfort and clarity.
The uses of a magnifier desk lamp are to able to see very small writing/print and be able to read this in a much better light. This can be used for older documents that may have been damaged in the past. Those with eye difficulties would be able to use the lamp for regular reading.
1.read the bottom of the curve 2. you must read the meniscus at eye level
If you place the multimeter leads on both sides of a standard light switch that is energized and in the "on" position, it will read the voltage of the electrical supply, typically around 120V or 240V depending on your region. This reading indicates that electricity is flowing through the switch as it is completing the circuit. If the switch were off, the multimeter would read 0 volts.
The best I can figure......TEACH ME TO READ
You can't read amps directly from outlet. You need to either put an amp meter in series with the current between the outlet and the load or use a clamp on ammeter on a single wire, not the pair of wires in an extension cord. Think about electricity being a vat full of water and the outlet as a spigot. To power a lamp think about connecting this spigot by a hose to a lamp. Also think about a return hose from the lamp to get rid of water. Until you turn on the spigot, no water flows so you can't measure it. If you try to measure in bot directions at once the flows cancel each other out and you get zero. To get a measure of flow you just measure flow in one hose or the other.
There is a particular type of office lamp which is best for lawyers with bad eyesight. Since lawyers must read many document, a lamp which doesn't have glare is the best choice.
It wasn't. There were no schools or education and 90% of the population couldn't read or write.
Yes, you would need an electric lamp to read the music when it's dark.
The reading lamp is a small light or lights certain older Chevy's have to help people read while its dark. usually they're either on the bottom of the rear view mirror or on the ceiling.
White spirit is what I use. I read it somewhere and it works well
Both are acceptable with different meaning. I read by the light of the lamp means I use the lamp to light the pages so that I can read them. I saw it in the light of the lamp means it was visible in that pool of light caused by the lamp.
It is better to read in daylight.
Read it.
Well, it depends on how dark it is. If it is pitch black, them no, but if your eyesight is good and there is a little bit of light then maybe. It is best for you to read when there is light, that will help you see better. If the tablet is glow in the dark, then maybe you could read it in pitch black darkness, but the tablet must glow very brightly.
I read in a magazine that she was afraid of the dark. But you can't always believe what you read in Magazines...
No, but you can read it in low light.
Read about it : http://en.wikipedia.org/wiki/Lamp_(electrical_component)