the library should have a shop manual for this vehicle, you can make copies of the right sections :)
infact i think the power supply be replaced with new one. infact i think the power supply be replaced with new one.
You can measure the current and power of a 'power supply', using an ammeter and a wattmeter. With the power supply connected to its load, the ammeter must be connected in series with the power supply's input. The wattmeter's current coil must also be connected in series with the power supply's input, and its voltage coil must be connected in parallel with the supply, taking the instrument's polarity markings into account.
It is not recommended to replace a 350 watt power supply with a 300 watt power supply, as the lower wattage may not provide enough power for your components. It's best to match or exceed the wattage of the original power supply to ensure proper functionality of your system.
Yes, you can replace a 12V 3.5A power supply with a 12V 4.5A power supply. The higher amperage rating means the new power supply can deliver more current if needed, which can be beneficial for electronics that may have varying power demands. Just ensure that the new power supply has the correct voltage and polarity to avoid damaging the monitor.
Check the headlight bulbs and fuses to ensure they are not burnt out. Inspect the wiring for any breaks or damage. For the power locks, check the fuse, relay, and the lock actuators for any issues.
The ground ciruit for the headlights is by way of the headlight switch , the lights always have power
the power steering reservoir
autozone had one for me
150 hp
To troubleshoot headlight problems on a 1988 Chevy Corsica, first check the headlight bulbs for burnouts and replace them if necessary. Next, inspect the fuses and relays in the fuse box for any blown components, as this can interrupt the power supply. Additionally, examine the wiring and connectors for any signs of damage or corrosion. Finally, ensure the headlight switch is functioning properly by testing it in different positions.
1998 Chevy cavalier with power windows are driver side window is down how can i jump the motor to raise it up thank you for your help
First check the fuse. Second check the switch. Same goes with power windows. A weak motor will melt a switch. If that fails ,connect a 12v power supply strait to the door in question.
I don't knw do any of u's knw wt it is
Next to the power steering pump
Low fuel pressure
a light greeny blue
Take it to the dealer. Trust me. It's a pain.