answersLogoWhite

0

The home ground of Inter Milan is the Giuseppe Meazza Stadium, also known as San Siro. It is located in Milan, Italy and is shared with their city rivals AC Milan.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Continue Learning about Natural Sciences

In a typical home electrical panel installation the main ground wire is connected directly from a ground rod driven into ground to the 1 case of the panel or 2 main breaker switch or 3 l?

The main ground wire in a typical home electrical panel installation is usually connected directly from a ground rod driven into the ground to the case of the panel. This helps to ensure that the panel is properly grounded to prevent electrical shocks and provide a safe path for electricity to follow in case of a fault.


Hot wires in home wiring are normally colored and ground wires in computers are normally colored?

In home wiring, hot wires are typically colored black or red, while ground wires are usually green or bare copper. In computer wiring, ground wires are typically black, while hot wires are often colored according to industry standards, such as red or yellow.


What is a floating ground?

A floating ground is an electrical circuit where the positive and negative sources are connected through a load to each other. They are not grounded to the earth. Your home wiring is grounded to the earth so does not have a floating ground. An example of floating grounds not necessarily the best definition, a flashlight, a cell phone, any personal electronic device when not connected to home wiring. The charger for these devices do not normally have a floating ground.


Should you attach the ground wire to the black wires?

No, the ground wire should be attached to the green or bare copper wire. The black wires are typically live or hot wires and should never be connected to the ground wire.


In the typical home electrical panel installation the main ground wire is connected directly from a ground rod driven into the ground to the?

In North American residential homes, there are 3 wires coming from the utility company, two "hots" and neutral. The two "hot" conductors get connected to the main breaker. The neutral gets connected to the neutral bus bars located along the sides of the breaker box. There is a set screw that is placed in the neutral bar that screws into the distribution panel enclosure thereby bringing the potential of the neutral bars down to zero. The wire from your ground rod is also connected to the neutral bus bar, and thereby it is connected to the neutral from the power company. This is also often bonded to the copper cold water plumbing in the house if the home is not plumbed in PVC water pipe. White circuit wires are then connected to the neutral bus bars. Also in the distribution panel are ground bus bars. The ground wires from circuit cables are connected to these grounding bars. Do not under any circumstance terminate the white and bare ground wires together. Ground wires to the ground bar and white wires to the neutral bar.